Results 1 to 6 of 6
  1. #1
    Member
    Join Date
    Feb 2012
    Location
    denton nc
    Posts
    21

    Question Carlos need advice on coin box console

    I just received my coin box from ranger. 2009 208 vx there is no plastic underneath the center seat except what seat is stapled to about 1 and half inch from coin box bottom to pan that ties seats together nothing to mount console bottom to . Only mount that would be the screws at back need advice...

  2. Member
    Join Date
    Jul 2006
    Location
    Oldtown
    Posts
    392
    #2
    Just did my 2009 198vx. Take that center seat out and all staples off...you use the plastic pad underneath all that....tape some paper to each of remaining seats and slide coinbox right in between. The paper will keep you from cutting the existing seat. Screw into the back with the four pre drilled holes. There was a tiny gap left so I took some black rope and slid it along back. You can check my thread here on Ranger service is of the hook and see a pic of install....super addition! I think my cell phone is also on my page, give me a call if that will help...


    [B][I]Jeff

  3. Banned
    Join Date
    Jun 2004
    Posts
    17,419
    #3
    Sorry for the delay, I was offline fishing!!!

    Jeff took care of it I think. Are you good to go? Again sorry for the delay

  4. Member
    Join Date
    Feb 2012
    Location
    denton nc
    Posts
    21
    #4
    Thanks guys I got the coin box in wonderful addition. Now when the old guys who fish with me will be easy for them to step up to back deck. And me to getting older myself.

  5. Banned
    Join Date
    Jun 2004
    Posts
    17,419
    #5
    good to go!!!

  6. Member
    Join Date
    Jul 2009
    Location
    Eagle River WI
    Posts
    292
    #6
    Any pictures?