Results 1 to 4 of 4
  1. #1
    Member
    Join Date
    Jan 2008
    Location
    Camas
    Posts
    242

    Hot foot installation on my 210?

    I need some advise on how to run the cables from the hot foot. Is it a top mount or side mount cable assembly that is run from the Hot Foot on a 210? Also, where is the entry point into the boat gunnel of these cables? I want to make it as clean as possible. Thanks.

    Pics would be a huge help!

  2. Banned
    Join Date
    Mar 2006
    Location
    Rock Hill, SC
    Posts
    3,051
    #2
    I went with the top-load model on my 198... The cable comes down from the top under the console where all the other electrical wiring comes in & is much cleaner than the bottom load that would run across the right side floor coming out of the gunnel just right of the bottom of the driver's seat on most late model ChamPs...

    Here's a few pics of mine: http://www.bbcboards.net/champion-bo...-hot-foot.html

  3. Member
    Join Date
    Jun 2008
    Location
    TN
    Posts
    13,947
    #3
    Gunnar that is a nice looking install. How did you secure the diamond treadplate to the floor?
    GETFISHED !!!

  4. Banned
    Join Date
    Mar 2006
    Location
    Rock Hill, SC
    Posts
    3,051
    #4
    Quote Originally Posted by getfished View Post
    Gunnar that is a nice looking install. How did you secure the diamond treadplate to the floor?
    Just 4-short stainless flat head screws + the screws that mount the hot-foot - 'Short' being the optimum word