Results 1 to 4 of 4
  1. 04-18-2006, 12:15 PM #1
    EJP
    EJP is offline
    Member
    Join Date
    Nov 2005
    Location
    Glen Burnie
    Posts
    1,792

    Where should I put the motor for break-in

    Okay so I finally picj her up after a long long long long wait this saturday. I took several days off this next week to go play ( ) told the boss I was going to be sick.... he knows whats up though. I know just about everyone is running the 202 / 250hpdi combo with the propshaft pretty much level to the pad. Is that an acceptable position for break in, or do I need to keep it lower for the break-in???? And you had better believe I have ants in my pants..... I can't wait....
    Reply With Quote Reply With Quote
  2. Rebel1
    Rebel1 is offline
    Blazer Boats Moderator Rebel1's Avatar
    Join Date
    Jun 2004
    Location
    Taylors, SC
    Posts
    12,993
    #2 04-18-2006, 02:09 PM

    Re: Where should I put the motor for break-in (EJP)

    I would keep it about an 1 in. below just to make sure you have good water pressure during break-in. Better safe than sorry. JMO
    Reply With Quote Reply With Quote
  3. Blazer Dave
    Blazer Dave is offline
    Member
    Join Date
    Jun 2004
    Location
    Tallahassee
    Posts
    125
    #3 04-18-2006, 04:47 PM

    Re: Where should I put the motor for break-in (Rebel1)

    I agree!
    Reply With Quote Reply With Quote
  4. spider1
    spider1 is offline
    Member
    Join Date
    Nov 2005
    Location
    Prairieville, Louisiana / Zolfo Springs, Florida
    Posts
    5,696
    #4 04-20-2006, 08:03 AM

    Re: Where should I put the motor for break-in (Blazer Dave)

    Now you need to send the lower unit to Titus so he can work his majic! and that baby will be a screemer for.







    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Motor break in
    By Tx 201 in forum Cobra Boats
    Replies: 4
    Last Post: 10-22-2010, 12:45 PM
  2. New Motor Break In On Pre-Mix, What Ratio ???????
    By Nikon Man in forum Mercury - 3 Liter & 3 Liter High Performance
    Replies: 7
    Last Post: 01-29-2010, 11:33 AM
  3. Done with break-in; Motor just ain't right
    By jpuryear in forum Champion Boats
    Replies: 13
    Last Post: 03-16-2009, 01:57 AM
  4. Motor Break In
    By chris20 in forum Mercury - 3 Liter & 3 Liter High Performance
    Replies: 1
    Last Post: 02-17-2009, 01:30 AM
  5. after break in on motor
    By pete 1 in forum Yamaha Motors
    Replies: 1
    Last Post: 03-04-2007, 04:59 AM