Results 1 to 3 of 3
  1. 03-25-2013, 11:30 AM #1
    bpNClgmouth
    bpNClgmouth is offline
    Member
    Join Date
    Feb 2011
    Location
    Simpsonville, SC
    Posts
    345

    Fiilling Wiring hole in transom

    Just ran some wires through the back of the boat where the screw in plate goes in over the rub rail. I had to take out some sealant to run the wires. My question is, is it necessary to silicone that entire hole back up or will the plate over top be sufficient?
    Reply With Quote Reply With Quote
  2. blackgts2002
    blackgts2002 is offline
    Member
    Join Date
    Feb 2010
    Posts
    858
    #2 03-25-2013, 11:36 AM
    Put some silicone back in there. If you have to ask if you should add sealant... I would just add it.
    Reply With Quote Reply With Quote
  3. fishin couillon
    fishin couillon is offline
    Lowrance/Garmin/GPS Moderator fishin couillon's Avatar
    Join Date
    Jun 2004
    Location
    Pineville, La
    Posts
    34,425
    #3 03-25-2013, 12:21 PM
    Better safe than sorry, seal it up all the way...
    YOU are not entitled to what I have earned!!!!!

    2014 Phoenix 619 Pro / 2014 Mercury 200 Pro XS
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »