got my filter and getting ready to install in in my skeeter...question is..can in install in between the primer bulb and the motor? the fuel line between the tank and the bulb is only about 12" long and i really dont want to have to replace it too..there is Plenty between the bulb and the motor..so just to be clear can it go...Tank--bulb--filter--Motor?
Chad
that is how I did mine with no problem
I believe that is how mine come from Skeeter
Mine is Tank-filter-bulb-motor.
YOU are not entitled to what I have earned!!!!!
2014 Phoenix 619 Pro / 2014 Mercury 200 Pro XS
Proper installation is tank-filter-bulb-engine.
BassinBarrister
2001 ChampioN 206 Elite
225 Yamaha VMax EFI
25P Trophy Plus Prop
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by BassinBarrister »</TD></TR><TR><TD CLASS="quote">Proper installation is tank-filter-bulb-engine.
</TD></TR></TABLE>
1+ That is how mine came pre-riged from the Ranger Factory.
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by BassinBarrister »</TD></TR><TR><TD CLASS="quote">Proper installation is tank-filter-bulb-engine.
</TD></TR></TABLE>
same on mine from factory, tank-filter-bulb-engine. I just wish there was more room in bilge compartment. I have to remove oil tank to get the cover off my filter to get filter off.
2005 G3 HP200 DC with 200hp V-MAX OX66
68.8 gps at 5600 rpm best speed yet
Where is filter mounted on your ranger?? I am about to install one on my 520. Pics would be very helpful!
thanks
It really does not matter how you install it. If it is after the bulb it will be easier to prime. Before the bulb you will have to remove the fuel line from the motor to be able to remove the air from the filter. I have had it both ways and as far as it effecting the motor or leaking at the o-ring I had no problems.
You can fill the filter with fuel before you screw it on but that gas will not be filtered.
<table width="90%" cellspacing=0 cellpadding=0 align=center><tr><td>Quote, originally posted by George.S.Sparks »</td></tr><tr><td class="quote">Where is filter mounted on your ranger?? I am about to install one on my 520. Pics would be very helpful!
thanks</td></tr></table>
My filter on my Z22 is in the back little lid compartment, driver side, right before the start battery. Mounted on the back wall of the storage compartment behind the driver. Don't have any pictures.
Spider1---You are right about priming the thing, but I just fill up the filter with gas before I screw it on. Yea it is not filtered, but I figured the Yamaha has 4 filters plus the secret filters on the motor,so that fuel should be filtered enough before it reaches the injectors, sense Mercury only require one filter.
Reply With Quote
