little help with parts??

[Pacer]

HydroTech did some work on my power head, and I am in the process of installing all the bolt ons. I just sent them the shortblock.

I'm having some trouble figuring out where a couple of parts go. I'm going to try to post a picture of the parts, but here is what I have:
Two plates that hold the electrical wires in place. I know the larger one goes somewhere on the back port side bottom, but I'm not sure where.
2 10mm flange hex bolts.
2 5mm allen bolts
1 small phillips head bolt
1 washer

I had some help taking it apart, so I am having some trouble putting everything back together. I didn't pull the crank position sensor off, so I am not sure what is supposed to hold it on. The small phillips is too small, and everything else is too big. This is a different block than the one everything came off of, so I am not sure if the bolt size that holds the crank position sensor on changed.


Thanks

[BuzzB8]

Have you tried using the parts link posted at the top of the page? With a little luck, you might see where they go.

[Pacer]

I've looked through the skimatics, and my manual several times.

I think the allen heads were used to hold grounds on in the electrical box. I found where the plates go. I'm still not sure where the washer, two hex head bolts, and the phillips head bolt go. I put the powerhead on the the motor yesterday. I should have it ready to run later today if I can figure out where these parts go.

Thanks

[Pacer]

The two hex bolts were for the back plastic piece that holds the coils. I found where everything goes except for the phillips head. Im thinking it was used to hold the crank position sensor on. If It was, I lost the other one.

I started it, and let it idle on the hose for a minute. I bled the oil pump, and checked to make sure it was pumping. It didn't look like much was coming out. Tomorrw I'm going to disconnect the linkage rod and hold it wide open to make sure it is pumping.