1989 xr4 150hp bored out to .20 I think??
Estimated cost to hone all 6 cylinder walls?
Expecting to maybe replace a few parts. Engine may have ran without oil for just a bit.
1989 xr4 150hp bored out to .20 I think??
Estimated cost to hone all 6 cylinder walls?
Expecting to maybe replace a few parts. Engine may have ran without oil for just a bit.
The hone job should come with the bore job. The question will be if it will bore and clean up enough at 20 thousands or will it need sleeves. I would figure roughly about 50 bucks per hole... or at least that's what it is around here.....
I just repaired my engine and i had 1 cylinder bored to .20 and the rest were honed , cost me $ 145.00 it would be a good idea to have a cylinder run out done . Any good machine shop can do this and be able to tell if all the cylinders need to be bored or honed
Reply With Quote