Guys I have a 200 pro sport bumble bee. I have a 25 trophy. Boat is sluggish never feels like it pulls hard just kind of slowly accelarates to between 73 to 76. Runs best at 3 1/4 below pad. Raise motor and rpms never go past 5680 and speed stays pretty much the same. On the smart craft and tach. Boat still lifts good at 2 3/4 feels like it lifts better with the trophy but RPM stays the same and speed fails off may be a mph or so not real consistent . when it ran 76 it was only turning 5680 rpms. Ran know good24 Razor 3 last night. Hole shoot still sluggish almost like it bogs off or stumbles as you come down on the throttle. Whole shoot was very similiar to the trophy maybe a little better. Mid range still feels sluggish just like the trophy. Boat feels like it is lifting good with both props it just never accerates hard. 24 razor 3 ran 74.5 at 3" below. Top end I am ok with, be nice if it ran a little faster but I had a 225 ox66 yamaha on this boat and it was a rocket out of the whole and pulled hard to 72 -73 mph in summer heat. Do I have a motor problem? I think the torque master has 1.6 gears but shouldn't I be able to turn a 24 3 blade past 5680 with this motor and shouldn't it accellarte fairly hard? I have been in several boats in my life and owned a few others. Been it one other boat with an opti it was a 250 pro xs same hull as mine and it felt alot stronger than this motor. Something doesn't seem right. Sorry for the long rant any help or suggestions is greatly appreciated.
Reply With Quote
Originally Posted by EuropeanAM
