Thread: Oil seal ?

Results 1 to 3 of 3
  1. #1
    Member
    Join Date
    Jul 2007
    Location
    Zion
    Posts
    3,275

    Oil seal ?

    I bought a used "homemade" utility trailer for hauling my ATV. As I plan on using the trailer for a 200 mile trip I figured I would disregard what the seller said about the bearings being new and inspect them myself. Well they were new, once. I am planning on replacing the rear seal and both bearings one each side but th eonly number I can find is the number on the bearings. All 4 bearings are Koyo L44643. Is there a way to find out the seal number with the bearing numbers? I can not find any manufacturer name or number on the axle, hub or any other part. I am not sure if this is a standard seal or what.


    \"Andy\", EM1 USN, Ret.

    Disclaimer:
    The poster does not take any responsibility for any bad feelings or sense of exclusion that the reader of this post may have-whether real or imagined. Reading threads poses inherent risks. The poster of this comment would like to also remind readers to make sure they have a functional sense of humor before they visit any discussion board.

    Everybody has a purpose in life... It\'s just that your sole purpose in life may be to simply serve as a warning to others.


  2. BBC SPONSOR
    Join Date
    Feb 2008
    Location
    Newark
    Posts
    304
    #2

    Re: Oil seal ? (flounderhead59)

    Are they oil bath hubs or grease? This should be the seal size you would need.

    http://shop.easternmarine.com/...D=190




  3. Member
    Join Date
    Jul 2007
    Location
    Zion
    Posts
    3,275
    #3

    Re: Oil seal ? (EasternMarine)

    They are grease and I was noticing the seal does not ride on the shaft but rather compresses against the inner race of the inner bearing


    \"Andy\", EM1 USN, Ret.

    Disclaimer:
    The poster does not take any responsibility for any bad feelings or sense of exclusion that the reader of this post may have-whether real or imagined. Reading threads poses inherent risks. The poster of this comment would like to also remind readers to make sure they have a functional sense of humor before they visit any discussion board.

    Everybody has a purpose in life... It\'s just that your sole purpose in life may be to simply serve as a warning to others.


Similar Threads

  1. Seal #
    By John Sanner in forum Trailers & Towing
    Replies: 1
    Last Post: 03-01-2011, 08:27 AM
  2. Seal?
    By TBDIRECTOR in forum Evinrude/Johnson Motors
    Replies: 1
    Last Post: 02-07-2011, 03:00 AM
  3. Oil seal on hub
    By Champ202 in forum Trailers & Towing
    Replies: 2
    Last Post: 07-30-2009, 05:54 PM
  4. What to use to SEAL ROD CORK ?
    By Ballistik in forum Clever Tips & Ideas
    Replies: 13
    Last Post: 02-25-2008, 07:13 PM