Results 1 to 4 of 4
  1. #1
    Member
    Join Date
    Feb 2011
    Location
    huntington
    Posts
    951

    2003 johnson 150 need advice!?

    Alright guys i need some advice i have a 2003 johnson that blew up well before it blew up it was acting up after it was warmed up. When i would first untrailer it would idle fine and run fine if i stopped to fish then go to run it would spit and sputter and stall out i could feather the throttle for a bit and then get it to run. Well i just had it rebuilt completly including carbs all seals everything well i the mechanic told me to run diffrent rpms and about 20gal through it to break it in about half way through i stopped to fish and when i went to run again it started to stall once again not as bad now because i backed out of it and then got into it alittle more and it jumped up and ran it did it both times i stopped for any length of time over probally 10mins. CAN ANYONE HELP ME WITH WHAT IT IS?



    Legacy outdoors prostaff
    legacy rods prostaff
    Knuckle down lures prostaff

  2. SC Club Moderator ChampioNman's Avatar
    Join Date
    May 2004
    Location
    Crawfordville, FL/Lake Hartwell, SC
    Posts
    72,219
    #2

    Re: 2003 johnson 150 need advice!? (dhayward)

    Try this first: http://www.bbcboards.net/zerothread?id=357667 if that doesn't help then adjust your idle speed jets out 1 full turn. You could also squeeze the primer bulb before you take off again from fishing OR just hit the choke on take off.

  3. Member
    Join Date
    Feb 2011
    Location
    huntington
    Posts
    951
    #3
    Ok awesome thank you i will check that out. I did notice when i hit the choke it wasnt as bad. Wat causes that?



    Legacy outdoors prostaff
    legacy rods prostaff
    Knuckle down lures prostaff

  4. SC Club Moderator ChampioNman's Avatar
    Join Date
    May 2004
    Location
    Crawfordville, FL/Lake Hartwell, SC
    Posts
    72,219
    #4

    Re: (dhayward)

    Ethanol fuel and also the throttle linkage not adjusted properly when a hot foot is installed. The throttle cable should be adjusted so that the throttle arm touches the roller on the throttle plate.

Similar Threads

  1. 2003 150 Johnson?
    By Dawnpatrol in forum Evinrude/Johnson Motors
    Replies: 2
    Last Post: 08-29-2009, 08:31 PM
  2. 2003 150 Johnson plug gap? Help....
    By MBragg8 in forum Stratos/Javelin Boats
    Replies: 2
    Last Post: 02-16-2009, 02:41 PM
  3. 2003 Johnson 115
    By Mikebuzz in forum Evinrude/Johnson Motors
    Replies: 2
    Last Post: 07-15-2008, 03:12 AM
  4. 2003 Johnson 150--Won't idle??
    By MadBass in forum Evinrude/Johnson Motors
    Replies: 2
    Last Post: 05-27-2008, 01:48 PM
  5. 2003 Johnson 175
    By NW.Ind.Basser in forum Evinrude/Johnson Motors
    Replies: 3
    Last Post: 04-29-2008, 04:05 PM