Results 1 to 2 of 2
  1. 11-23-2010, 10:13 AM #1
    bass-ackwards
    bass-ackwards is offline
    Member bass-ackwards's Avatar
    Join Date
    Nov 2004
    Location
    Deltona, Fla
    Posts
    1,328

    No Trim Hold in Reverse

    .......'98 225 evinrude, fas trac system. When in reverse the motor will come right out of the water when I step on the gas. With it up on the tilt rams it will come right up and out...on the trim rams she will come up quite a bit......Other wise works fine. Suggestions??


    [http://westvolusiacustombaits.shutterfly.com/
    Reply With Quote Reply With Quote
  2. ChampioNman
    ChampioNman is offline
    SC Club Moderator ChampioNman's Avatar
    Join Date
    May 2004
    Location
    Crawfordville, FL/Lake Hartwell, SC
    Posts
    72,219
    #2 11-23-2010, 11:18 AM

    Re: No Trim Hold in Reverse (bass-ackwards)

    Check the manual release screw and make sure it is fully tightened.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Anyone know how to get a hold
    By coachallen in forum Texas Fishing
    Replies: 6
    Last Post: 04-20-2011, 07:50 AM
  2. hold on, here it comes
    By flwillie in forum Florida Fishing
    Replies: 7
    Last Post: 01-26-2011, 07:53 AM
  3. Motor won't hold trim position
    By Texas Rig in forum Yamaha Motors
    Replies: 2
    Last Post: 05-07-2008, 04:26 AM
  4. OK I Can't Hold Out Any Longer!!
    By Varsity Basser in forum Cobra Boats
    Replies: 2
    Last Post: 07-11-2006, 03:58 PM
  5. hold on.....
    By cchamp in forum Texas Fishing
    Replies: 15
    Last Post: 04-29-2006, 08:57 AM