Does anybody know how to change out the boat seat. Mine is all tore up and I'm fixing to get a replacement but can't seen to take it off. Can't find any snap buttons, fixing to give up and just use a towel. The Ranger dealer here wants to charge me $550 to replace and the upholstery shop is even worse at $800. Thanks I'm new to this site and excited to talk about fishing. Thanks.
Here is whhat you need to do right here. Go to the boat seat store and get a set of there seats and do it yourself. Here is how I did mine http://www.bbcboards.net/zerothread?id=332728
$550 is actually not too bad for factory-replaced seat covers installed. For help getting the seats out, a picture of the seats or a boat model number would help. If your seats have a center peice in the back, then that center peice is help in place with velcro and just pulls out, exposing screws that hold the frame of the seat in place. Good luck
GO STEELERS!!!
Not sure your boat, but I had to replace mine in my 362. Getting the old bench out was a PIA! After searching on here and seeing all the answers and even talking to somebody at Ranger, it was still next to impossible. The back of the bench has a SUPER STRONG velcro that pulls up to reveal the bolts. I went with the boat seat store and they are great!
Reply With Quote