I have a 1999 fitch and where my trim relay connects to my pdp the is a burnt spot where one of the relay prongs goes in. Trim want work. Brand new relay. I can push the relay to the side and it will tilt and trim. I'm thinking I may have a break in the wire. Also my check engine alarm started going off and my boat would run rough when put in gear and sometimes shut off but runs great on plane.Thinking it may be a throttle position sensor. What do you guys think?
IM sent.
http://img.photobucket.com/albums/v4...redownload.gif
"If you're going to mess with the king's queens, you better watch your ace, jack!"..http://img.photobucket.com/albums/v4...821/images.jpg
www.thayersmarine.com www.zekoshoes.com
If you are handy with a soldering iron you can take the PDP of and remove the back and repair it if it isn't burnt too bad. Your other option is DFI Technologies for repair or purchase new. As for the alarm problem I would advise you to have the software hooked up and retrieve the fault code to know where to start.
Dan Burnette - Marietta, GA
Triton 18TRX - 200 HO G2
Jeff A thanks for the help it was my pdp. It was burnt beyond repair. I got one from a Buddy of mine and it did the trick. Thanks
Reply With Quote
