Crankbait makers?

[swilliams]

I know a lot of you guys are crankbait makers. My question is how to you attach the lips in your baits? I purchased a crank bait recently and the micarta bill fell out of it. Asked the retailer and they just sent me new one but didn't want the old one. I want to fix the old one if possible. It looks like it was not even glued in.

Thanks,

Steve

[Ky 520c]

Devcon 2ton epoxy(sold at wally world) drill a hole in the lip where it sits in side the body spread the epoxy on both sides and in the hole,straighten the lip and let it the dry

[swilliams]

I appreciate the response and the IM's guys.

[jvandergraff]

I use a product called Z Poxy, you can get it at Gander mountain. Two part epoxy that sets fast and stays a little flexible.