Thread Master

[Ryan]

My Thread Master has turned a milky white. Will it hurt to use it on a finish? Thanks for the help Ryan.

[Jay Carroll]

Your epoxy or color seal?

[Ryan]

It is the Part A resin.

[WCR]

TheradMaster recommends heating the bottles in a microwave for about 6 seconds before you mix the 2 parts together. I just set the bottle of epoxy in a bowl of warn water about 20 minutes before I was going to use it, then do a test batch to check.
More than likely your problem is the temp of the room and the temp of the unmixed resin and hardener. The room needs to be at least 68-70 degrees to achieve optimum results. This is not just with TM but with any resin system.

Lynn

[thedude]

nuke it for a few seconds, it will turn back to normal.

[Ryan]

Thanks I will give it a shot. Ryan.