I have some spot remover jig heads and some strike king finesse worms......prob. I am having is that it is very diff. to get the head of the worm onto the shank of the jig. Worm sooo plyable it wont let the shank stick into it. Any sugg..?? Or what the crap am I doing wrong?? Thanks!
http://www.basspro.com/servlet...rowse
just put it around the eyelet & crip shut with pliers. Should help hold your bat batter but angle may be a little different. might have to bend hook shank down a little for better alignment tto.
you would be surprised at what just a drop of Pro's Glue will hold!!I used some on a SnapBack fluke and a jighead and it didnt come off till I pulled it off
For shakey head worming I just use a plain round headed straight shank jig head with a spot of Super Glue Gel near the head to pin the wom on. I leave the hook exposed since I don't use the rig for fishing bottom. I'ts a really good bait over shallow gravel, sand, mud, rock or out in open water around a point.
Jim
SONAR & GPS, Basics and beyond...http://www.hightechfishing.com/lowrancetips.html
MY EMAIL Ouachitabassangler@gmail.com
Go to http://www.lblures.net email Larry and tell him to make you up some "Shakey Heads" with the "Hitch hikers" on them and that will eliminate all your problems.
Bob...
Hoyt, we have been manyfacturing the Shakey Heads with the coil attached for easy rigging. We have also found that by this attachment it does not allow your bait to spiral on the fall and give you much unwanted line twist. You can view the pics on our site. Hope this helps.
Jason
http://www.hookerztackle.com
BBC Sponsor
Reply With Quote