RPM and H20 pressure numbers?????

[Joey's Bullet]

I have a 99' 200 Evinrude Ficht on my boat. I would like to know what the rev. limiter is if anyone knows. I would also like to know at what h20 pressure I should be running at WOT. I ran yesterday and the tach read 7000rpms at wot, i hope that this is not correct. I have the motor at 1.5 below pad and a 26 Raker prop. Have plenty of jp left to go up, but even now when i am running in curves if i dont trim down the h20 pressure drops off to around 12lbs. Any help would be much appreciated, most Bullet guys have Mercury's, I seem to be the odd ball!! Thanks JOEY P.

[THE WITCHDOCTOR]

I believe your motor should stay below 5800, with 5800 being the most.... w/p if I am not mistaken doesn't need to be below 18 or so.... But one of the guys might know a little better than me...

[Joey's Bullet]

Thanks Witchdoctor I called Evinrude and the limit is 6000rpm's and around 13-16lbs of water pressure. Guess I should have called them before posting here.

[RUSTY63]

The rev limiter is @ 6500 but, I would not suggest you run it over 5800.