Need help to I’d replacement part…PLEASE!!!

[theflyguy]

I have an overheating issue on my 175L Pro XS OptiMax (model number 1175P73EY), (serial number 2B121880).

I want to replace the following parts to see if I can resolve the issue.
- Poppet Valve
- Thermostat’s
- Any corresponding gaskets for these parts.

I don’t know where to search/find the needed parts.

Help Please, if you have the time.
TIA

[EuropeanAM]

ALWAYS, ALWAYS start AT THE SOURCE: The Water Pump!

96148A8.

Moving your post to the CORRECT (2.5L) forum.

[theflyguy]

BP serviced the motor last Oct and installed a new impeller…this has been going on for some time…lots of $$ going out but NO resolution!

[JOE54]

redo their work again to be sure its right replace all 3 gaskets and impeller make sure seal is in top housing for copper tube and oriented correctly , plastic part goes in first , be surprised how many so called tech cant do a water pump correctly , seen this many times

[SilverFox579]

Here's the correct way to service the 2.5L Optimax water pump, step by step, with pictures - Water Pump Replacement

The FAQ sections at the top of this and the 3L forum are chock full of helpful topics and info to keep your Optimax happy.

[06 SB]

Didn’t you just have a thread about this where the alarm is not a steady tone but a series of beeps?

[EuropeanAM]

redo their work again to be sure its right replace all 3 gaskets and impeller make sure seal is in top housing for copper tube and oriented correctly , plastic part goes in first , be surprised how many so called tech cant do a water pump correctly , seen this many times

+100... and don't be surprised if you find a torn gasket below the impeller plate or below the water pump base.