Still available?
Type: Posts; User: Glenn B.
Still available?
:thumb up2:
I believe it is setup correctly for starboard side. Your comment is correct for yours, which is port side install.546996
I bought a used Echomap Plus 93SV, LVS 32 setup a little over a year ago. It has the 13.40 software version, which I believe is the latest for this unit. I have it mounted on Fortrex shaft with the...
Thanks guys.
NOCO advised me today that my GEN4 is not compatible with lithium.
The newer GEN5 and GENPRO are required for that purpose, as some indicated.
Have seen both yes & no comments so thought I'd post with pix.
Will this NOCO charge lithium batteries??
Thx in advance.
Thanks for the reply 21XDC.
Mechanic did just the impeller but all else was inspected and looked good.
I'm certainly no expert, but the temp sensor seems to be operating properly. Alarm sounds when...
Chasing this for a bit now....
New impeller, new thermostats, new poppet valve (grommet, gasket, spring and mushroom head).
Idles great, pee's great.
Run up the rpm's and temp climbs and alarm...
Anybody have one laying around they would like to unload? Lost mine.
Thx!
Perhaps a silly question but...are there supposed to be washers & nuts on the inside of all 4 slidemaster jack plate bolts? I have them on the side with the talon mounted to it but none on the other...
Thanks MichAngler.
Just to clarify.... onboard = engine tank and external = bilge reservoir tank - correct?
So by your comment you feel it is likely a sensor on the external bilge tank.
2001 ZX225 w/ OX66 225 VMAX - low oil light keeps coming on, no alarm. Every time it does I check both onboard and engine reservoirs and they are full or near full. Seems oil is still getting pumped...
Anybody got one they might want to unload?
2001 ZX225 - Looking to remove and replace seats. Driver & passenger easy enough, but I cannot figure out how to remove the center seat/step. There are 2 bolts (not screws) on the back end of the...
I have a 2001 ZX225 that I am cleaning up. Looking to replace the carpeting and leaning towards outsourcing it. Got a quote for 20oz carpet - $2100 with padded front deck and $1800 w/o. Going to seek...
I have an HDS7 gen2 touch at the console. It has both the regular 2d ducer and the lss-2 ducer for down/side scan. I am having issues with losing the regular 2d sonar. I have isolated the issue to...
WTB Lowrance LSS-2 transducer. Please PM or post here if you have one available. Thanks.
Have blue connector. Good to go. Thank you sir.
So I am seeing various differing posts on this........I am installing an hdi transducer on my trolling motor. I have an HDS 9 Gen2 Touch unit up there. Can I direct connect the ducer cable to the...
Looking for a cover for my ride but prefer to not spend big $ on Aurora, etc.. Anybody have one they might part with? Other suggestions? Thanks in advance.
When on the lake with the flow rite valves set to "closed" I still had both livewells take on water. I'm assuming it's not the flappers since, when I got off the lake, the water remained in the...
Have port & stbd livewell fill switches on the dash with on/off/auto options.
Both work fine and fill when switched to "on" position but I get nothing when switched to "auto".
Shouldn't the...
Looking for help....having an issue with the fuel selector valve on my "new to me" ZX 225. It doesn't want to draw gas in any position - port, starboard or dual? Connected the primer ball & hose...
Buddy has a bunch from doing similar work on his boat so I am just buying it off him.