No warranty it’s 2017 model .
Type: Posts; User: big ike
No warranty it’s 2017 model .
Not leaking at seals. Compressor air shot in top of shaft, soapy water shows bubbles where the shaft attaches to housing.I under it’s epoxied together.
Water getting in motor where the shaft attaches to motor housing. What is best way to seal, an epoxy or flexible type like marine grade RTV. Any experience with this problem? Thanks
Will it run using foot controller switch, or continuous switch? Has to deployed to test.
Remove propeller loosen one of two through bolts see if water runs out. If it has water inside need to...
Looking to buy a spare spool for my new Stradic xg 4000. Wondering if older models are interchangeable?
Thanks
Sounds like the Reed switch needs adjusting. ...
Rig you a 1/8 copper tube on compressed air spray valve seal off with rag best you can stuck in from top of shaft while someone sprays motor (prop removed) area, mine was leaking where shaft attaches...
I have Gen 1 ulterra, does it have boat scale settings also ?? My spot lock aggressive at times. Thanks..
I agree, certainly was on mine. Bolts were good tight, o rings looked good. So I put end caps back on, seal off air nozzle at end of shaft with wet rag while my son sprays soapy water around lower...
I have an ultrex 112 water in motor issue.
Been on the boat less than a year. Bought at a salvage store for a what seemed like a heck of a deal. No marks showing ever been installed, remote...
Found the water entering lower unit where the tube attaches to motor housing. While pressuring from upper end of tube spraying index all around motor housing bubbles coming from where tube attaches...
My guess, water intrusion. I have one apart drying waiting on parts that was full of water. Motor was slow to start, full speed had dropped from 3.7 to 2.7, noisy. My research shows lots of those...
Thank You !
I have motor taken apart drying out, I was thinking put back together stick air spray nozzle in shaft seal off with rag let other person soapy water that connection area . Gonna put all new o rings ,...
Is there a gasket for the built in transducer? I don’t see one listed on parts diagram. Water has gotten in and I want to replace any thing that could be allowing water entry. Also not sure how to...
I found water in the motor being the problem. Boat had sat for a week no water had seeped from any place soon as i loosened one of the through bolts (which seemed good and tight) not sure what torque...
Must be water in motor, wires tight and I removed propeller. What is common way water enters ? Thanks for the input.
TOP SPEED WAS 3.7 MPH BEFORE NOW TOP SPEED IS 2.7, PUT NEW BATTERIES IN NO CHANGE. ALSO THE MOTOR RUN SWITCH ON THE FOOT PAD IS SLOW TO RESPOND. ANY IDEA WHAT THE PROBLEM COULD BE? THANKS
Thanks to all responses. I'll be ordering the core 51mg7 gear upgrade from tackle trap. Thanks again!!
I have a curado 51e that has a Geary feeling when reeling, have put all new bearings except the anti reverse bearing. Gears have been cleaned and greased with no change. Looking at teeth with a...
I have older model maxumm 101, (maybe 02) that has the D shaft (no pin) it seems to have excessive end play allowing the prop to rub against the housing creating a squealing noise. I put a new prop....
I had interference on mine also. I have my electronics and pumps on a dedicated battery. when I hit the tm I'd get a 3/4 inch wide dark vertical streak mostly on sonar side. I drilled and tapped an...
thanks... the akorn is made by chargriller, its double wall metal construction with insulation in between top & bottom plus a fire bowl in the area where the charcoal goes so that area is triple...
I like them cedar tables too!! so I built one for my akorn!!59107