Search:

https://www.bbcboards.net/showthread.php?t=1096269&highlight=

My 2020 Z20 weighs 4,120 lbs. Just FYI


https://www.bbcboards.net/showthread.php?t=1096269

I

Can I ask what your prop to pad measurement is now? I also have a Z20. Thanks

Can I ask what your prop to pad measurement is now? I also have a Z20. Thanks

PM sent

Thanks Marc. Ive done just as you say and everything seems to be working properly now. Thanks for everyone's assistance.

Will do . Thank you

Both bow and console HDSs were on when I was having the issue. When I got home yesterday I checked it again with only the bow HDS on and it correctly showed my waypoint then.

Good idea. I’ll give it a shot. Thanks for the help guys

I have the console unit using the Point 1 for GPS and heading. I have the bow unit using the Point 1 for heading and the unit itself for GPS. It sounds like I cannot have 2 heading sensors on my NMEA...

Hello. First time out with a Ghost today. I have key 3 or 3 dots key set to drop a waypoint. When I do set a waypoint it shows 20+ feet behind the boat. Even when im not of moving. Any ideas I why it...

Just bought a Ghost trolling motor that comes with a Aftco Lowrance Barricade Jacket and Bibs. Don’t need ‘em. You pick the size. Jacket and bibs in link below. Asking $200 shipped. Retail...

Mercury Pro XS 250 V8
SN - 2B737776

I’m changing out the water pump for the first time on this motor. Should I be in fwd gear or neutral when I put the lower unit back on? Also, is there anything...

Micro SD card is correct. I usually put the card in the left slot but I don’t think it matters.

Just pulled my 2020 Z20 cross country with the Outer Armor cover on. Performed beautifully. No issues. As stated above I removed my windshields and graphs. I also wrapped the rub rail with plastic...

Well I wonder if I even need the Minn Kota sensor for my Ultrex? Haven’t ever used the jog feature which I understand the MK sensor is for??

I’m looking to add a Point 1 on my 2020 Z20. I have the factory MinnKota heading sensor mounted on the starboard rear top cap but I’m hoping someone can tell me a good location they’ve found for...

My current setup is Carbon 12 hooked to a AI 3 in 1 in Ch2 and a Airmar TM150 in Ch 1. but my down/side scan freezes as others have reported. I’m wondering if the setup below would work and if it...

Almost the same boat but I have a Z20/ 250 4S with a 25p Bravo 1 FS. Very happy with overall handling of this prop.

I’m running a 25p Bravo 1 FS on my 2020 Z20. I’m happy with it. I get about 5900-6000 rpms in summer. I’ve seen 73 in the cooler months.

Yes

Something in the motherboard quit working. Dealer installed a new board and it’s worked fine ever since

I used 8-32 screws. One inch length. My Z20 trailer has five screws on each side

Just an informational post in case anyone was wondering. Today I Cat scaled my 2020 Nitro Z20/ 250 4S with moderate gear, 1/2 tank of gas, no poles, 4 group 31 batteries. Website specs seem to be...