I tried to jump my Optimax 225 with my Noco GB40. The battery voltage was 10.2 according to gage.
Motor. Would turnover but not fire.
Voltage too low?
Type: Posts; User: holic
I tried to jump my Optimax 225 with my Noco GB40. The battery voltage was 10.2 according to gage.
Motor. Would turnover but not fire.
Voltage too low?
Thanks again Don. Taking it to dealer today
Thanks Don. Is it possible to go into Guardian Mode without an alarm going off?While this is happening would this throw a code that would show up when they run a scan.
When it goes into safe mode will it feel like I just pulled back on the throttle. Then go again as soon as I give it gas until I hit 4900 rpms again? Maybe the rev limiter?
No warning horn. No smart craft. Hate to half to do that on a pontoon boat but might have too.
lt acts like I just back off the throttle when it happens. Motor was just serviced with water pump...
Motor reaches 4800 rpms runs fine.
Motor drops to close to idle at 4900 .
Motor is on a new to me pontoon.
Has a great hole shot and purrs.
sn#2B627015.
Thanks otdrzman. But it’s a System Monitor not a Mercmonitor.
06 225 Pro XS # 1B389384.
I posted in another thread about a Mercmonitor.
I actually have a Mercury System Monitor.
Question is does System Monitor show an engine check light and a
bell when...
Is there actually a count down on smart craft when in break in mode?
Yes I keyed off engine several times.
Only beep I get is at key on. Scan is next.
Thanks Don.
Engine Issue 1b389384
I replaced compressor, inline oil filters and thermostats on my 225 Pro XS.
Took to a mechanic to prime oil system and bleed system with a DDT.
Took boat to the lake and...
Wrong forum
Thanks Don.
My Manuel says 30 ft lbs for compressor, mounting bolt torque.
Facts on BBC says 20 ft lbs. which should I use? The bolts are black. Thank you
New ones are made the exact opposite of my old ones.
I guess just follow same arrow direction. With arrow pointing away from compressor?
Do I have to cut the check valve out of oil return lines to...
1B389384. Sorry. Fat Finger Syndrome.
Fixed it. Serial # 1B3893846
Had a squeal coming from engine when power loading boat on trailer.
Compressor pulley was solid but had a clicking noise while rocking pulley back in forth. ...
Replaced my inline oil filters.
Is there a way to flush these?
#1B389384
I used a screw driver to pry up slightly on all four corners.
Probably not the right way to go at it but i was not using it again.
Would not budge otherwise.
Got it
Won’t budge. Any special tricks.
Going to replace. Want to know why it’s clicking and won’t come apart.
#1B389384
Thank you. Will be looking into it.
06 225 Optimax serial 1B389384
https://youtube.com/shorts/boX9mxljul4?si=MgZxD3iDWz-1q2Fl
Thoughts on this clicking.
Pulley is rock solid.
I just happened to check it because I heard a little...
Can you post a video from iPhone.
Having problems. Won’t upload keep getting error message.
AC Delco marine starting battery.
I got they battery to finally accept a charge from the trickle charger.
It might take awhile.