Oh yes and my set up was in a 2023 puma sts also
Type: Posts; User: MDWood
Oh yes and my set up was in a 2023 puma sts also
When I set mine up I put a 50ah lithium battery in one of the rod lockers - just used some stick on velcro on the bottom of the battery then just hooked the power wire thru a switch then to battery. ...
Pretty sure Ken ordered a Puma
I took the second console out of my Puma for the first time but question on putting it back - when I took it off one of the screws came out with a fiber washer but on the others some of those same...
Don't remember if this was mentioned earlier in the thread but you might also go to Ken Smith Fishing - he did a comparison of several boats last year when he was looking to get a new one. He...
It does make it higher but they really look good.535895
So would the grease seperate out so that what dripped out looked like regular 30 weight motor oil. For grease - what kind - on other boats I used lucas red n sticky. I took off the bcb caps on the...
I have a 2023 puma - yesterday I pulled the wheel hub covers and the little black plastic covers on the hubs and 3 of the 4 had what looked like regular motor oil in the cap and dripped the same oil...
On amazon - frabill conservation telescoping tear drop net - $80 - just got one for my STS and fits easily and very long handle.
In some a nickel will fit in the lock out slot with a slight tap.
I have tandem axles but should be similar I just wanted the boat to be level while towing so adjusted the trailer tongue till boat was level then measured from hitch to ground then got a receiver...
New STS with 2 8'blades full fuel on port tank 1/2 on starboard. Full live wells, medium load, 2 people - at the moment the 31 crank battery and 3 regular wet cells (it came that way) I ran the...
Seems the drain hole in my Puma is over 1" which is what flowrite says is needed for their remote plug. Factory said there is someone out there that makes a sleeve of some kind to reduce that hole...
I have a 2023 Puma STS that has the regular Jack Plate - does it need a Hydralic Plate?
Thanks
I measured it on a 650 and there's not enough - the loc r bar bracket top to bottom is 1.5" - I'll have to figure something else.
thanks
I need to check and maybe add a small amount of sea star stearing fluid to my 2013 Alpha 211. The access is hooked to a tube about foot or so long with a cap on the end of it - can anyone tell me...
I'm considering getting a 625. I do some tournaments that require overnight stays in hotels etc. From looking at the height of the gunnels on the 625 has anyone put in a loc r bar - looks like...
I just did the that swap in 2021 on my 2013 211- the only way to get at the bottom bolts thru the transom is to remove the tank. While it was out I had all the pump cartridges and the flowrite valve...
I actually asked the factory that exact weight question - answer was - depends on when each factory weighs the boat - blazer weighs the hull and top cap before anything goes onto it - no hardware, no...