Search:

Disconnect wires going to stop switch and test again.

What is the model number?

I've tried them all and my Bauer from harbor freight has been the best so far

Those are for the sync and link procedure

I've used the weldwood original in the red can on roughly 30 boats with zero issues. I don't brush it on. Been using a cheap siphon feed gun from harbor freight for years with no issues.

Thank you sir

I'm working on a 115 S/N 5725708. It has the trim cylinders beside the transom bracket and the trim pump it remotely mounted in boat. Just wondering what trim fluid is recommended.

Just curious because I know nothing about the merc 4 strokes but without a bulb if the user runs boat out of gas will the fuel pump reprime the engine after refilling tank?

There's also a metal cased fuel filter between the vst and high pressure pump that could be checked.

I'm not saying it's not bad but if it wasn't putting out enough pressure I can't figure how it would put oil and fuel in the water. I have seen them put out to much pressure especially on the 2.6L...

I would also check the filter baskets on inlet side of pump.

Also flagship Marine used to rebuild them. Not sure if they still do

For the price of that pump I would recommend getting it hooked to a computer and look at high pressure reading

I've had good luck removing most of the old glue with oscillating tool and scraper blade

I will say that you probably don't want to use the carpet from bassboatseats.com. I've had a few customers bring me their own carpet that they purchased from there and it is not very good. I've used...

What is the difference between the 2?

Will a XM 9 20 MSI T work with a helix 10 MSI+ gps g4n?

Oscillating tool with scraper blade does a good job also flap disc.

I've suggested it to some of my old customers with HPDI and they have definitely seen improvement

You guys have to understand that I was a certified Yamaha tech for 15 years. I've worked on thousands of HPDI engines. If someone was running yamalube you wouldn't see plugs that look anywhere close...

Yes. I am. 87 octane gas also

I know Don but I get busy and forget. LOL. I will also mention that probably 60% of those hours are idle time.

Just wanted to share what running the cocktail does for you. I know I should have already changed these twice but almost 175 hours running the cocktail. 2008 250 proxs optimax.Appreciate it Don.545006

Sounds like trim relay to me. The click in the relay indicates that it's getting power from the switch. That doesn't mean power is going through the contacts to run the motor. Swap the blue and green...

My son and his partner ended up winning the juniors state tournament down there. Now off to the world finals.