Yes
Type: Posts; User: PSM207
Yes
Trip your trigger
IMO, the Razor 4XL is an exceptional propeller.
∆ THIS ∆
Charlie - What's your setup; hull, prop, setback, prop to pad and speed?
Koma - It is possible to visually verify the throttle body at the engine for full open position.
Koma - Hot Foot or Shifter throttle?
PM sent
It's also possible that the throttle linkage is not adjusted properly and not allowing the engine to actually go full throttle.
Marine Metal Products offers several types of aerators for different applications. I've used the one in the attached link with very good results in my boats over the years. Simple, cost effective and...
Depends on your particular climate, along with the season. Colder conditions usually dictate a lower viscosity.
I run 5W-30 in my SHO and all of my other vehicles.
PM sent
Tim - I greatly appreciate your input and expertise. Thanks!
FWIW, I do plan on hard mounting the batteries once I've found the optimum location. I also have tackle, tools and cold storage in both rear compartment, all of which needs to be balanced out. I've...
Performance tin, oxymoron
I've not had any issues with the batteries moving around. My initial plan is to secure them after I run the boat to test things out. I also have high amperage connectors to allow for a safe and...
If using screws, keep them short with approximately 1/2" of protrusion below the compartment floor surface. Also be careful when drilling pilot holes for any screws, as the compartment floor is close...
Insulation only slows the transfer of heat and does nothing to add heat.
I'm salivating.
Also check primer bulb. I've seen the parts inside these bulbs break and restrict fuel flow.
If you read over multiple boating websites you'll find that powerhead failures are not limited to one specific brand. Unfortunately, Yamaha had an issue in the early 4.2L years which seems to be at...
Just how far north?
I wouldn't give much credabilty to anything from MSN.
The Yandina products work well. I've used them in 3 of my boats from current to over 20 years ago.
Tape measure and Amazon.com is how I did mine.