Thank you
Type: Posts; User: fastguy
Thank you
Is a 250 SHO equipped to support nmea 2000?
There are no boat lanes, south of the 334 bridge is pretty much open water.
the lake is at full pool, 322'
I'll check that tomorrow.
I used the screws provided with the sensor.
It is mounted in the back of the boat on the starboard side.
I guess I just can't have nice things
I used a compass to check for magnetic interference, didn't have an issue. i have managed to get it to within 12 degrees in any direction, checked with the compass in the boat and an I phone compass....
I recently installed an external gps antenna with a heading sensor, it is connected to a Helix 10 with the latest software update, it will read correctly going north but is 20 degrees off heading...
Thinking of switching from Garmin to Humminbird and really like the fuel used data that is available on my Garmin.
I have a 225 Tohatsu with a NEMA 2K backbone already in stalled what else will I...
Does any one have an oil filter suggestion for the new 250 4 stroke?
A friend just bought one and the local dealer cut him a deal and sold him one for only $28.00.
Yamaha wants the lower unit back un touched from the dealer. They are shipping a new out to replace it, should be here Friday.
This is just one of the reasons that I bought a Yamaha.
They replaced the claw washer the last time it happened. This is the second go round with it.
It isn't very fast but it is one frugal sucker on the fuel front. Runs 67 68 with just me.
I live on a...
I have had to take my boat to the shop twice for the same thing, the nut that holds the bearing carrier in the housing has backed out and allowed the bearing carrier to spin in the gear case. This...
If you run 30 miles per day the 4 stroke is quite a bit cheaper to operate, An oil change and filter will run you about $35.00, that will be it for 100 hours. I run one on an Allison and have over...
Mine is installed after the bulb also, I loosened the filter located on the engine and pumped the water separator filter full of gas,then the sediment bulb on the engine filter. I rigged my own...
You win the prize,that is exactly what it is, they changed the lower unit on the lift and the damper fell out.
Thanks for the reply.
George
I think it is coming from the powerhead, the tell tale is running a good stream. Is there anything that could be missing in the mid section that would allow this to happen? One of my fishing partners...
A friend of mine just had the lower unit replaced, now the exhaust is louder and there is warm water coming from between the mid section and the skirt.( Sorry about using the Mercury terms) The...
If you are talking about the new Command Link set-up I have the instructions some where.
Give me a call, if I did it anyone can.
George
316 204 4816 ...
Larry, I am running one on the back of an Allison 2003 XTB. I really like it so far but I only have 11 hours on it.
The oil deal is a big deal, as is the smoke.
Yamaha has a great reputation for...
There is a pink pig tail that must be connected,it is located at the front of the engine. Then you initialize the gauge setting. It works.
I am impressed with this system, the speed reads the same...
I don't know what it is set for, how can you tell? Some diagram that came with it shows a pig-tail off of the ecu with a pink lead. It is setting on a lift I guess it will wait till 10 hours.
...
Recently installed Command link system on F150, everything works with the exception of the trim indicator.
Are there any connections that needed to be made under the cowl?
I set it per the factory...