Search:

Type: Posts; User: badMackrel

Page 1 of 20 1 2 3 4

Search: Search took 0.01 seconds.

  1. What would cause the tachometer to be very wrong all of a sudden?

    Just had a jackplate installed and I replaced all the switches in the console..first trip out since.and now the tachometer shows me at 9000 rpm at WOT. Lol. I have a vessel view mobile so actual rpm...
  2. unfortunately that is not a strong point for me.

    unfortunately that is not a strong point for me.
  3. what do you do when the wiring diagram is wrong?!

    i replaces switches and now trying to figure out how to wire them. Yes, i took a couple of photos but they are not totally clear. i saw that i have a wiring diagram under the back lid. so i thought...
  4. Replies
    2
    Views
    213

    Calibrate trim gauge?

    Is it possible to calibrate the trim gauge? The needle seems to be off by a quite a bit. Everything functions, just annoyed the gauge is wrong.
  5. Haven't run the boat since I added the jackplate....

    Haven't run the boat since I added the jackplate. Hope to do that tomorrow. Just wanting to get to recommended max rpm range. And get a bit of bow lift. Since the bow is heavy and the stern is light....
  6. If you had 5800 rpm using a 21 pitch, would you...

    If you had 5800 rpm using a 21 pitch, would you assume the rpms would be less if using a 23 pitch? I thought the larger the pitch the slower the prop spins. Is this correct?
  7. Oslo switches/ round push button switches replacements?

    I have a 2016 z518 and it has the round latching switches made by Oslo. They get stuck. I have noticed the switch mechanism is fine, the cap is what gets stuck. Has anyone found a way to get these...
  8. Anyone move from Rev 4 or Fury to Bravo 1 fs? Or from Rev4 to tempest?

    Below is the Mercury recommendation of changing from a Rev4 or Fury prop to a Bravo 1 fs. Was wondering if it is actually true, the RPM should be the same with increasing 2 inch pitch.

    Anyone...
  9. Do you run the jackplate low or high to get top...

    Do you run the jackplate low or high to get top speed?
  10. 2016 Z518 w/ 150 4S (not proxs) on a jackplate - What prop are you using?

    I have just added a jackplate to my 2016 Z518 with a 150 fourstroke (not the proxs version). For those with the same setup, what prop are you using and what is your elevation? I am guessing a...
  11. Replies
    1
    Views
    246

    Storage compartment mats on R series

    I saw a walk thru of the z520R and the bins behind the seats and in front of the console look to have mats in them . does anyone know if they will fit older boats?
  12. Replies
    19
    Views
    894

    Thanks. Great info. I odered a jackplate. I am...

    Thanks. Great info. I odered a jackplate.
    I am just trying to get back to the speed before the lithiums and dual graphs.
  13. Replies
    19
    Views
    894

    @jps. What is the exact model of the 21p solas? I...

    @jps. What is the exact model of the 21p solas? I am seeing a few versions.

    And thanks for the great detailed response! Gives me hope. :)
  14. Replies
    19
    Views
    894

    I don't have the proxs . Just the 4 stroke. And...

    I don't have the proxs . Just the 4 stroke. And I ordered a jack plate this morning. So we will see if that helps . Next is a tempest plus prop or a Razor prop from Croxton.
  15. Replies
    19
    Views
    894

    21p around 5200 rpms max.

    21p around 5200 rpms max.
  16. Replies
    19
    Views
    894

    it absolutley came with a rev 4! i purchased a...

    it absolutley came with a rev 4! i purchased a brand new 2014 Z118C which is the exact same boat as the 2016 Z518. And it came with a Rev4 from the factory. I asked the guy I purchased the 2016 from...
  17. Replies
    19
    Views
    894

    bow lift effected

    I purchased a new to me 2016 Z518 w/150 4stroke. Has a 36v trolling motor, helix 9 and garmin 12" graph with panaoptics at the bow, panoptics mounted to trolling motor. no jack plate. With lithium...
  18. Replies
    4
    Views
    446

    it just seemed like a lot. but it is probably...

    it just seemed like a lot. but it is probably correct.
  19. Replies
    4
    Views
    446

    Lithium ah usage question

    I recently got lithium batteries. Using a 125ah starting batter. Went out on the water using only 2- humminbird helix 9 graphs. And started the motor a few times. The battery indicates it has 78%...
  20. Replies
    3
    Views
    203

    I would love a ranger cover. Didn't know I could...

    I would love a ranger cover. Didn't know I could buy one
    .
  21. Replies
    3
    Views
    203

    Z518 aftermarket travel cover?

    I bought a used 2016 z518 which did not include the travel cover. Anyone recommend an aftermarket travel cover?
  22. Replies
    7
    Views
    1,606

    do you have pics of the completed panel? And how...

    do you have pics of the completed panel? And how did it work out?
  23. ah. i googled it (probly my first problem), and...

    ah. i googled it (probly my first problem), and it returned an article saying the 24 draw was 30 amp, and the ultrex was 38 amp. And then i just now found this great article which confirm what CatFan...
  24. lithium batteries 50AH or 100ah with 36v ultrex

    Got a new to me boat. thinking about lithium batteries. Has a 36 volt Ultrex. was wondering if anyone is using 50ah batteries with a 36v ultrex and how is the performance? previous boat had a 24v...
  25. Replies
    3
    Views
    155

    Well..just found that they don't share map cards.

    Well..just found that they don't share map cards.
Results 1 to 25 of 491
Page 1 of 20 1 2 3 4