Thanks
Type: Posts; User: JohnnyB 1
Thanks
What I thought, didn't see the one I need
531487
Is this the correct service manual?
These should work then?531485
Labor is free, lol. I'll be doing it. May have to ask a few questions though
J90pleeb I believe is the number
ChampioNman, boat is new to me. Only had it a few months. Previous owner couldn't get it to run so he was fed up an sold it pretty cheap. I've been working out issues and had it running good up to...
Found this from sei
531482
All three have some damage
Alright guys, finally had a chance to pull bearing carrier. Chipped gears is the issue. What's the best route to take now? Buy new gears, seals, water pump, or just look for a used lower?
Got home from work and checked prop for any noises. Smooth. Can metal build up cause the ticking? I'm pulling to checkout anyway, just wondering what would cause that noise
Thanks guys
Any special tools besides a puller for the bearing carrier?
I have a 1999 90hp johnson that has developed a ticking when in gear. Sounds fine in neutral. Drained the fluid an it has some water in it. Metal shavings on the drain plugs. Fluid had been changed a...
Need recommendations for a ladder on a 17' javelin
Thanks
I would if I had them. New boat to me. Just looking for similar replacements
Any suggestions on replacement seats for this boat. Something similar to original
Appreciate it
The prices on these things are ridiculous. The buttons work on mine but the rubber cover is missing. Any alternatives
Recently purchased a 17' venom, white boat with black/red flake trim. Looking to renew the finish. Wet sanding works well for the white, but I have yet to see a difference on the black red flake...
All carbs reacted the same with paper, would suck it in affect motor idle. I did find issue with fuel delivery to motor. Found plastic line from new fuel line packed in line at anti-syphon valve....
Believe I found culprit for the fuel issue. Previous owner had changed primer bulb and line from tank. Where the new line connects at tank was packed with clear plastic, at 1st I thought it was fuel...
Pulled the carbs off my motor this morning looking for anything obvious causing the motor to starve for fuel after running wot after a few hundred yards. All looked ok on the carbs except for one...
Will check. I pulled the bowls off one of the carbs last night. Laid on a flat surface you could see it was warped. Not sure that's a issue as there is no fuel leaking anywhere, yet