Test
Type: Posts; User: GoldenBear
Test
Test
Test
72 also, as long as legs don’t give out.
Is AGM battery’s lighter in weight than wet-cells? And Lithium is lighter than AGM.
Just pull over to A cove at ramp it want take 45 seconds. It was noisy that morning I did mine so my partner stood up at front fishing pedestal seat and worked the go and turn while I got down to...
Love mine, no more head bumping. When I open it after a long day on water NO water comes out.
The main reason was to use in middle position (butt seat) when grandson went along……purchased a base for seat from a marine and took it back seeing the shaft was bent. That was embarrassing after...
On the bottom of seat you mount seat mount. Question is on the mount is a word that says FRONT. Is it right to say if your mounting on a chair seat the FRONT would go toward front and on butt seat...
Just ordered 2 kits from Ranger today, all I needed was the inter plastic ring the part that the locking clip catches against. They come in a kit, 2 were around 100 bucks.
I fished with a guy last week that has the Ghost on a Z119c and I was watching him when he would put it into the water he would step down on flat plate to latch it. He had it installed by a dealer...
2016 Z119c, F250453228
Stratos told me not more than a 8 inch on my 2007 201 with a 225 Mercury.. And I put a High Jacker 8" and love it no problem raising or lowering the motor....$300 and $92 to install.
IMPORTANT NOTE: 1-2 ounce comment above is for ORIGINAL TORQUEMASTER and/or Sportmaster model gearcasesONLY.*
Standard, Servicemaster, or Wingmaster gearcases should be filled "to the bottom of...
Greg what is your prop to pad measurement? And do get ant chime walk?
132967 Don could this be the problem it looks like one Black piece come out of the cradle and it came unsnapped.
Ser.# 1B389368......went to load boat on trailer today when leaving dock I pulled it back for reverse and it just click click click so I go back to neutral forward OK. After doing this 3 or 4 times...
Got the same boat and motor but it's a 2007. It came with a 25 Templest plus (Mark balance it) ......8" jack plate..3 1/4 below pad..5900 rpm,s..GPS 72 chimes at 67.
It's true, ONE day turn around and the job is next to none...
No oil anywere on the back side or front.
Had it posted in Trailer section no one answered all day so I posted in Stratos fourm. I seen that sticky on oil bath but it looks like oil baths go to edge of hub mine have a gap u can stick your...
They not buddy bearing wish they were.
Have 4 of these on 2007 Stratos trailer. The guy I purchased it from knows nothing about the boat in general. Wanting to know the kind of bearing so I can service in the future.
This is on 2007 Stratos trailer..it does' t push in.
Ok I got my answer from Don' Most comman ask question.