Search:

Type: Posts; User: Grits and gravy

Page 1 of 9 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    7
    Views
    378

    If you are really worried about it. Put a shop...

    If you are really worried about it. Put a shop vac on the oil fill port as keep a vacuum on it. Then remove the drain plug and replace washer. Just make sure to not have a lot of vacuum or you will...
  2. Replies
    12
    Views
    1,235

    You could easily repair that yourself. Order the...

    You could easily repair that yourself. Order the correct gel coat from Ranger and watch a YouTube video on gel repair. That would take about 1 hour total over to repair and cost about $40 for a pint...
  3. Apply silicone sealant inside trim and use heat...

    Apply silicone sealant inside trim and use heat gun to soften the plastic trim and then reinstall.
  4. Replies
    14
    Views
    1,031

    Repower with a Yamaha 250sho and flash it to...

    Repower with a Yamaha 250sho and flash it to 320hp. Keep the rev limiter stock to maintain the warranty. You will get everything you are looking for. I have a 2018 521L and I’m running 70mph fully...
  5. Looking for LVs 32 system

    Looking for LVs 32 system
  6. Replies
    7
    Views
    478

    If you have a dremel or round file, you can use...

    If you have a dremel or round file, you can use the led ones from etrailer. They are a lot
    brighter and only take a minute or two to install. They are just slightly bigger and only took a couple...
  7. Replies
    12
    Views
    554

    If you already have a shop vac, just get a good...

    If you already have a shop vac, just get a good 5gal bucket with lid and run a small plactic hose out of the lid and hook up shop vac to hole on lid of bucket. The suction will draw the oil into the...
  8. Get the Yamaha and send the CPU to hydrotec....

    Get the Yamaha and send the CPU to hydrotec. Leave the rev limiter stock so the warranty is still in tact. My 2018 521L is running 71-72 fully loaded with my SHO. Never had any issues at all.
  9. Replies
    9
    Views
    961

    The bigger boats don’t see as much top end gains....

    The bigger boats don’t see as much top end gains. But getting out of the hole is another story. It never rises, just gets on plane as soon as I hit the throttle. My old 519 with flashed 200 was...
  10. Replies
    1
    Views
    178

    There is plenty of room to mount it in the...

    There is plenty of room to mount it in the standard place. The charge is much smaller than most other chargers. The 5th battery does not take up that much room.
  11. Replies
    9
    Views
    961

    Yamaha T2 25 pitch. I have a 2018 521L that is...

    Yamaha T2 25 pitch. I have a 2018 521L that is currently running 71-72mph. Before I changed to lithiums, it would hit 74mph. The rev limiter was left stock. Gets out of the hole great, and I usually...
  12. Replies
    14
    Views
    732

    With lithium there is no need to hook back up...

    With lithium there is no need to hook back up before going out. The discharge rate is so low that it won’t amount to 1-2% over a month.
  13. Replies
    1
    Views
    200

    2018 521L phone charger issue

    Not sure it is really called a phone charger, but the 12volt plug and phone charger on my 2018 521L do not have power. I assumed it was a blown fuse but have traced the wire from the plugs to the...
  14. Replies
    5
    Views
    370

    Ranger parts sells them $.50 each

    Ranger parts sells them $.50 each
  15. Xylene works better at getting the glue off than...

    Xylene works better at getting the glue off than acetone. It does not evaporate as quickly and softens the glue faster. And it does not affect the gel coat.
  16. I had a 1992 451V and it was a good boat. With a...

    I had a 1992 451V and it was a good boat. With a 150 it was fast. But it was small too. If you fish by yourself, it is fine, but cramped with 2 people. The price does seem high. Mine was in very...
  17. My 2018 trailer had an issue with jumping teeth...

    My 2018 trailer had an issue with jumping teeth on the axle. Changed out the bolts for grade 8 and the hub that had problems bolt had stretched a tenth of an inch. Changed the bolts and no more...
  18. Replies
    10
    Views
    930

    I have been told there is an angle, but I...

    I have been told there is an angle, but I measured the tire clearance on the fender before and after I reset mine. I had one that had jumped splines so I measured the good tire and then set the other...
  19. If the pedestal is stuck, use a strap wrench to...

    If the pedestal is stuck, use a strap wrench to get it loose and then get a sanding flap wheel for a drill and sand out the pedestal hole. It does not take much. If the lids are soft, take off the...
  20. Replies
    2
    Views
    502

    Usually the stress cracks are pretty shallow but...

    Usually the stress cracks are pretty shallow but caused by flexing. If you hit something and caused the flexing, then you can sand out the cracks and re gel coat the area. But if it is caused by...
  21. Replies
    8
    Views
    422

    Or look at getting a 36 volt lithium battery....

    Or look at getting a 36 volt lithium battery. About the same size as 1 group 31 battery and has 50AH
  22. Replies
    13
    Views
    659

    I have already ordered the bolt kit. I checked my...

    I have already ordered the bolt kit. I checked my other bolts and they were all a little loose, so I tightened them down also. Hope it keeps me from buying an axle and hubs.
  23. Replies
    13
    Views
    659

    My front passenger side tire keeps jumping spines...

    My front passenger side tire keeps jumping spines on the axle. I’m going to get new bolts and tighten them down to 150 ft/lbs to make sure that is not the issue. If it keeps up, I will have to...
  24. Replies
    17
    Views
    630

    Does anybody have the bolt specs? Size and...

    Does anybody have the bolt specs? Size and thread pattern? Gonna try this fix on my trailer before I order a new axle.
  25. Replies
    3
    Views
    393

    Where did you find the axle? New or used.

    Where did you find the axle? New or used.
Results 1 to 25 of 215
Page 1 of 9 1 2 3 4