I have used Schaefer's Ultra Moly after their demonstration at the shop 20 years ago. Just pulled my rig @ 75 mph for 2.5 hours to the house and the hubs were cool to the touch. Very please with this...
Type: Posts; User: Bullet[BS]
I have used Schaefer's Ultra Moly after their demonstration at the shop 20 years ago. Just pulled my rig @ 75 mph for 2.5 hours to the house and the hubs were cool to the touch. Very please with this...
You are going to have a very short day on the water if you don't replace those batteries. They will not completely recover getting that low.
I found this thread from way back I hope it helps.
https://www.bbcboards.net/showthread.php?t=605640
Thank you for your post. I bought one off Amazon and it worked great!!
The Ferite ring did not help my Lowrance. I have put shielding tape on the TM head between the TM & the transducer. I have moved the wire away from the foot pedal and it's still there. I even changed...
I had this trouble in the past, you probably have a tire that is slightly out of round. Thats why it will only happen in a specific speed range. It took buying a set of Michelin's to get rid of it. I...
Found 1 more in my stash :)
530874
Sea Foam Deep Creep is the best Penetrating oil out there. We use it at the shop.
I had a broken wire where the 10 pin main wire harness transitioned into the outboard. I found the following schematics during my trouble shooting. I hope this helps. I used my Multimeter on...
You can attack the rust with Osfo.
https://www.ospho.com/
I have this set up in my boat right now. What I did I setup a bus bar and ran fused power wires to each graph & side scan. What I did do different is I ran power to a 3 position switch. Up supplies...
Napa sells liquid electrical tape if you want a different solution.
I had a similar issue I ended up running a new power wire for the running lights to fix the issue.
Corrosion can cause this problem as well. Look at your cables very closely rusty and or corroded cable prevent the full charge getting in the battery and prevents getting all the power out of the...
If I may chime in here, great suggestions on what to use. BUT what glue do you use?
Butt connectors come in several different sizes, you can get a connector that is yellow one end (large) and blue on the other to make a cleaner connection for your grounds.
https://www.homedepot.com/p/Everbilt-Zinc-Plated-Steel-Trailer-Safety-Chain-810612/204765170?source=shoppingads&locale=en-US&&mtc=SHOPPING-CM-CML-GGL-D25H-025_003_FASTENERS-NA-MULTI-NA-SMART-NA-NA-NA-...
I did find this Kilr bee
https://www.marinepartsguys.com/product/turbo-lube-hub-kit/
Take a look here for schematic info. I have been told that Skeeter uses the same wiring schematic they just keep adding stuff to it.
...
Peppermint Oil and cotton balls. Soak them in the Peppermint oil and place them in the openings on your trailer, I would put some in the boat as well to keep them out of there too. We use it to keep...
I found this I hope it helps.
525507
Well Done!!
Sounds like you have a wire rubbing through that just isn't all the way through yet.
I was having issues with my electronics as you use your cranking/accessory battery voltage would get low enough to create issues with my electronics. I added a 27 series just for my electronics and...
You should be able to check it in both places. What are you trying to figure out?