Search:

I have the all in one transducer does that need to be selected?

Hi setting up new HDS live units on my boat and while cycling through screens found that while out of the water in the driveway both downscan and side scan say "no source" assuming transducer has to...

Thinking of putting a stowaway graph mount on my 2023 520. Does anyone have opinions or pics on how they work on Ranger models.
Thanks

Just took delivery of a 2023 520R and had a question about the travel cover. The boat has a bicycle seat (front) and folding seat (rear). The dealer had the bike seat in a post hole in the cockpit...

This is the push button start system not the code and pad system….

Hi Just took possession of a 2023 520R cup equipped model and have a question re; the push to start function. Mine seems to be a little finicky to start but eventually does. Is there a trick about...

Hi,
I just took possession of a 2023 Ranger 520C that's been on the dealers lot since last spring. The center jack is very difficult to move into the down and locked and up and locked position....

Just upgraded to a Ranger 520 and will need to swing away the tongue when parked in the driveway. Does frequent opening of the swing away increase wear and tear on the trailer wiring? Any tips for...

Hello,

Looking to purchase a back up power cord for my 2019 Ranger trailer (Serial number 7J5BBCJ29KF166704). The connection underneath the trailer hitch appear to have a male/female coupler that...

Hello,

Looking to purchase a back up power cord for my 2019 Ranger trailer (Serial number 7J5BBCJ29KF166704). The connection underneath the trailer hitch appear to have a male/female coupler that...

On my previous Mercury outboard (non 4 stroke) there was a screw that could be loosened to manually trim the motor in the event of an electrical problem. I don’t see anything in my manual for my 225...

Looking for feedback of anyone has put ultimate bunk boards on a ranger trailer. Their supreme board requires a 2 inch off center to secure and wasn't sure if new hardware would be required to...

Hi
Looking to put an auto boat latch on my trailer for my 519 and looking for opinions on these 2 from those using them on their Ranger trailers
TIA

yes to both. new boards and centered on the brackets

Hello,

After swapping my trailer bunks for Gatorbaks (2019 Z519) I'm having difficulty with the alignment of my long bunk boards and get a push to the left when winching up. I've loosened the...

Yikes my bad!! How much play should they have I was able to move them by hand and that felt loose. I guess it's something I never looked at before i noticed this at random

I recently noted my bunk boards were loose and tightened the mounting hardware on the ramp. Unfortunately I think I tightened them at the wrong angle as the port side chine doesn't sit well without...

Got a gouge taken out of the rub rail near my bow on a dock last night. Is there any product I can use to fill in the defect? Not big enough to consider replacing the rail but still looks bad
Thanks...

I've read that with gatorbak bunk covers that applying some wax occasionally can help with loading. What wax do people recommend?

I'm going to be swapping out the bunks on my ranger trailer. I use a 9/16 socket to tighten the current lag screws (flanged) but can seem to find this size anywhere. Does anyone know the specs for...

With a nominal size 2x6 actually only being 1 1/2 x 5 1/2 is it safe to use a 1 1/2 inch lag screw or should one use a one inch screw to prevent inadvertently having the screw protrude on the loading...

Hi looking to replace my bunks and would like to switch to gatorbaks. My question is how challenging are these for the mechanically challenged to install on the 2x6? Haven't seen a good video showing...

They do but the cost and shipping were outrageous. i was quoted about $400 per bunk !

Hello

I have a 2019 Z519 and need to replace the bunk boards. Going to be a while until I can get to the lake and can get her off the trailer. Measuring it with the boat on I get 12 feet for the...

Will be replacing my trailer bunks and was looking for opinions on the best piece of wood. I have heard cedar may be the best choice but wondered how that would hold up to lag screws??
Thanks for...