I installed a hot foot in my boat, I want to make sure the cable is adjusted properly. should that butterfly touch the stop when WOT. If so I can’t see to get it to open that far.
524853
Type: Posts; User: Michael Stelly
I installed a hot foot in my boat, I want to make sure the cable is adjusted properly. should that butterfly touch the stop when WOT. If so I can’t see to get it to open that far.
524853
New owner of a 98 triton TR18 with a 2014 Pro XS 150, 2B113749. I replaced the spark plugs and noticed all 6 I removed were not gapped correctly. They were all set .030-.032”, was that the original...
Thanks. I guess the TR18 does not have recirculating pumps. I replaced both fill pumps and one of the pump out pumps.
thanks, I have replaced all the terminals on the switches. My current problem is that some of the wires were so corroded and they fell off from where they were attached and I am not sure where they...
Hi, I agree with the wires corroded, several of mine were bad, cut some of the wire off and put new terminals. I only see two aerators, two live well pumps and one Bilge pump. Should I have...
Thanks, I found one from 2004 model. On my panel they have two aerator switches, one ACC, was this common? and do I need both. Only have rear port/starboard live well with drain pumps. All but one...
New to me, 98 TR18 with 2014 Mercury Pro XS 150
523492523493523494
Hello, new owner of a 98 Triton TR18 with a 2014 Mercury Pro XS150. I am looking for a picture of the wiring of the main switch panel, color code or wiring diagram. I am replacing corroded...
Double post
Shop called today said it’s the power pack that’s causing intermittent loss of fire. Ordered power pack, hope this solves the problem.
Thanks. Local shop said key won’t work? I mean it’s a momentary switch. Guess I could try.
I am having trouble with my 97 Johnson Fast Strike 150. I would like to remove the Johnson and install my xri 150. I know the control cables are not the same, how do I remove the OMC control box. ...
Twice it has left me in the water. Not sure I can trust it. Compression average 110lbs
Same type of problem I am having. I am following this
Went out on lake on Friday, motor cranked easy. Slow speed from launch then got on step. Almost immediately the motor sputtered slightly and died. Would not start. Used troll motor to get out of...
Ok. I will call them in a few minutes. Thanks
I took boat to local shop. They pressure checked lower unit and determined it’s the seal under water pump that’s bad. They offered two quotes, one for just that seal and another from prop seals...
Thanks for help.
thanks. I was quoted three to four hours of labor to repair plus parts of lower unit. Do I need special tools to replace seals. The lower unit is easy to remove
I changed water pump and found water in lower unit oil, milky oil. I took boat to local shop a week ago but they have not got to it yet. I loooked around for a working lower unit, found a GT150...
Thanks for information. My lower unit has water in oil so the other stuff will have to wait.
I will check the weekend. The prop is 23p
Today I picked up a super clean 282 FS with a fast strike 150. Test rode the boat and it ran very well. The speed of the boat is way lacking compared to my previous Astro boat. I guess it would be...
Any 200SX owners, I have the opportunity to purchase a 200Sx without a motor. The Mercury 150 was removed and sold. The gel coat would need wet sand and compound. Seats are not perfect but usable. ...
Awesome. Thanks for information