Hi. I am in Frankfort, KY and lately have been fishing Cedar Creek quite a bit. Anyone else spend time there?
Type: Posts; User: srsmith
Hi. I am in Frankfort, KY and lately have been fishing Cedar Creek quite a bit. Anyone else spend time there?
Thanks for the information. The video was very helpful!
I am running a stock Tempest Plus 23 that came with the vent holes plugged. Playing with me new Z118 boat setup I am hitting close to 61 (GPS) at about 5550 RPM with just me 1/2 gas and 1/2 livewell...
Thanks for the info. I am actually getting about 16 PSI at 61.
I have a new Z118c Ranger with a 150 Optimax ProXS and a newly installed 6 inch manual jack plate. I raised the motor to 3.5 below the pad this week and ran 60 (GPS) at about 5550 RPM this AM but...
I have a new Z118c Ranger with a 150 Optimax ProXS and a 6 inch manual jack plate. I raised the motor to 3.5 below the pad this week and ran 60 (GPS) at about 5550 RPM this AM but am wondering about...
Great looking boat! I just bought my first "real" bass boat a couple of weeks ago, Z118c.
Well it wasn't the dealer's fault that's for sure. I wasn't measuring correctly. Bill Day came to my house and personally measured it with me. It was my faulty measurement. It really was a little shy...
Thanks will do tonight. I did call the dealer and go ahead and order an 8 inch jack plate. From what I read, iy should be set with the prop at 3.5 inches below the pad right?
Thanks, I will check into measurement. Skeg is about 1.5 off the floor.
Thanks! Maybe a jackplate will get me closer to where it needs to be.
Thanks for the great info! I have only had the boat 1 week and about 3 1/2 good hours of running time. I don't have a jackplate and right now the propshaft is over 9 inches below the pad. Just wonder...
Thanks for the info!
I have a new '15 Z118c and am wondering about top end RPM. I ran some WOT yesterday after the initial 2 hour break in. There was moderate chop and some headwind, but with the motor trimmed just about...
Thanks! Should finish official break in on the motor on Saturday
126022126023126024126025126021
My new Ranger I purchased from Day's in frankfort KY. They rigged the boat and had had it ready for the water less than 24 hours after i first looked at and bought...