Search:

13 21XRD, did the same. Lost a little when I went to a 36v Ultrex, lots more weight on the front than the old MG's and weight that far forward matters a lot. Then went from 3 lead/acid to one 36v li,...

Kyle I just measured the old lower and the new one, the new one is more than an inch longer.

Hard to believe it would make that much difference but about to jack her up and see


fingers...

21XRD/250 ProXS (2 stroke) TM1, 3/4 below.

Was running a Bravo 27 and lost it/the lower when I hit something a few weeks ago. Hole shot was decent, blew out a touch but overall not bad, top end...

Assumed that was the case but wanted to ask

Thanks!!

21XRD, 250 ProXS. Have run the Bravo with 4 vents forever, think maybe that's the FS? Regardless, lost it when I hit something a couple weeks ago.

So my question is- does anything really change...

Thanks Reb

Need a 27 for a 21XRD/250 ProXS. Mine's at the bottom of Lay Lake.

Middle of the channel just above Shelby Shores, 79 MPH, with my youngest sitting next to me. It was an awakening...

21 XRD, 250 ProXS (2 stroke)

Had a Croxton 28P Bravo 2 on there for years, till today anyway.

Any suggestions on what to try would be much appreciated, if anyone has any I should try that's...

Lanier has monster spots, it'd make me cry to be close and not chase some of those chubby girls...

Lay Lake Bullet Fan

I'm stayin' away from yours brother :)

Have to come pick on the fat girls with me one day once you move back home

Where their always chewin',,,539072539073539076539077539075

Heck brother, I'm happy to pay. Just fish so much this time of year it's tough to send them for recover. With these reviews looks like that's the way to go though. About to hit Crank again...

That's actually who I was going to have recover mine WVBullet, just ran out of time.

Was actually planning to use one of the guys on here and reupholster, prefer to do that, but we fish so much this time of year it made it about impossible from a time perspective.

Thanks guys

Crank may just be our local shops but the 2 I went to, they wanted as much to redo mine as new ones run, +/-$1400. I would just get the group that does Bullet to send me new ones before I'd do that....

If I remember right the replacement (2 seats) was +/- $1200 from whomever builds them for Bullet.

May be the way to go, not sure, wanted to ask first though

h

1. Engine Serial Number- 1B705050
2. Year/Make/Model 2013 Merc ProXS
3. Prop you are Running 28 Bravo
4. Current Maximum RPM 6200
5. Idle and WOT Water Pressure Readings Idle- 3 WO 15
6....

Thanks!

I'm running a 2013 250, staying around 155-160 at 5500-6000.

Usually fish in the winter, not so much in this heat with 93-97 degree water temps so wanted to see what everyone else's optis ran.

h

Had a local wrench that finally got to the bottom of it. Ended up being a fuel rail gasket/seal, can't remember which he said for sure but she's screaming down the river like she should now
...

Good call on the plugs, two were way off. Fixed them and that cleaned up the idle issue but the miss/drag feeling is still there starting at 5250-5300. Putting the timing light on it this evening,...

didnt seem as bad though. Ill

It had it before the plugs, seems to be worse now though. I'll hit it with the timing light.