Wayne. Would Apex units benefit from new Ethernet switch. Running direct still best?
Type: Posts; User: Blue Ranger-Z518
Wayne. Would Apex units benefit from new Ethernet switch. Running direct still best?
It's not too hard. I did mine with 8-gauge duplex to dash and too bow. Use fish tape etc. Going from back to bow a little harder. I removed right speaker/vent under dash and also pulled out the push...
Go with Ranger Z518 200 pro xs. Extra power and better take off. Power when boats loaded, plus looks better than 150.
I Have interference with Apex 13 with my Mega 360. It's worse now after update. Needless to say, disappointing.
I was thinking of doing my 2022 Z518. I heard it's a hassle with the foam. Any pics of how it looks now, with tubes out. Is it Worth it?
I upgraded my Sonars a little while ago on my Z518. I replaced my Solix 10 in the dash with APEX 16. I replaced my Solix 12 in the bow with an APEX 13. The Apex 16 at my dash is really nice and I can...
No plug. Only your controls.
Thx It looks like I won't be needing the Ethernet switch. My Ultrex has the I pilot Link Cable Which is 30 feet. They don't have a shorter one from what I've seen, correct? it's an 8-pin...
I purchased an Apex 13 to put on the bow of my Z518. I moved my Solix 12 G3 to the console. So, when I connect the ethernet cables. Apex to Solix direct to each unit and then Ultrex (si/di) to 5...
I have a 2022 Z518. Great boat. The 200 ads that extra power. Good ride. Big waves you'll notice. Good Storage. The tandem rides real nice. Harder to put in the garage with tandem, doesn't like to...
My kit arrived in the mail today. Thx Ron
Nothing yet for iPhone. Not Showing?
It's a good box 5025, either way depending on space. I changed my mind and changed to separate blocks and put on hard plastic plate.
2022 Z518. 3700 boxes. Megabass Pouches. KVD bags. Remade center storage dividers.
Will Mega 360 work with an Ultrex Mega SI/DI. Will it read the Mega DI from trolling motor with Y cable? I should be able to get a split screen with MEGA 360 and MEGA down imaging.? THX
I double checked. looks like 21' 6" give or take from edge of motor 200Hp to tongue, motor down. Full length motor to end of trailer 23" 8', tandem axle. Motor up adds another 7 or 8 inches. I did...
My 22 Z518, 200 pro Xs with no jack plate is around 21' 6". The 21' 7" pretty accurate.
All my 3700 wouldn't fit in my 22 Z518 sideways. The waterproof boxes were to tight too. The smaller 3600 will work for sure. Need like 1/4 to 3/8 inch more space on each side for the 3700 to fit...
I have a 22 Z518 with 200 Pro Xs with no jack plate. Dual console. As of now the highest speed was 64-65. I only went that high once, just to see. I think she can do more. Too fast for me. The...
I have a 22 Z518 and I took out their rails and made my own. Now I can put my 3700 in flat or I can stack up right, very little room for rods. Laying Plano's flat I can get rods in but not that many,...
I have a 22 Z518 but I didn't like the fact that I couldn't put my Plano (3700) boxes in the center storage left to right or sideways. I could only put them in length wise. So, I modified my own by...
I emailed them twice, it took a couple of days, but I got a response, but it came back as Junk mail. So, check your junk mail or spam.
I did Graphics, it took around 6 hours in between stops. Running out of Goof off and just taking time.
Picked my new Ranger 2022 Z518. Three hours on engine so far. Seven more to go. Going well.
Mercury 200 Pro Xs
Ultrex Di/Si
Solix 12 G3 bow
Solix 10 G3...
Thx. Yes a 200 PRO XS, No jack plate yet . Ill put more pics when I pick her up.