Newbie mistake ... Data sharing was turned off.
Type: Posts; User: z385198
Newbie mistake ... Data sharing was turned off.
When viewing side vu and down vu in a spit scree combo, do you have to have your Down Vu frequency set to 810 Khz when running Side Vu at 1070 Khz or can they both be set at 1070 Khz and adjusted...
I recently installed and networked two 126SVs. However, while on the water yesterday, I marked a few weigh points at the console and when I went to the bow of the boat, the weighpoints were not there...
Got it - thx!
Not overly concerned ... I was just curious if going to the home screen will remove power from the transducer?
When stowing TM to run to a new location, does going to the home screen disable livescope, and its transducer? I'm curious if doing so will eliminate the potential for overheating the transducer...
Is there any benefit to calibrating the compass on your livescope if you do not have a heading sensor or NEMA antenna installed on your boat?
Thanks
Great - thx!
Yesterday, I prepped my hull, and installed the tank with 3M Marine adhesive (slow cure). My question is, do I need to wait 5 days before I add the marine antifreeze to the tank?
Thank you for your...
That's all I needed to hear ... Thanks!
The protective covers that come with the 126SVs snap on really nice and securely. Can you trailer with them on the graphs without them blowing off?
Mine clicked too but still will not tighten.
Will do - Thanks
I recently ran new network cables for my graphs and FFS. The 2-piece connector(s) that Garmin provides, which allows for easier routing is nice, but I have one that does now screw up tight at the...
I used "Posi-lock" connectors. They are amazing connectors. I believe the 10 guage posi locks are yellow and you can easily attach the smaller guage power cords to them.
Thanks everyone
What's the best /safest thing to clean your screens with?
I am considering purcahsing the, BFE Garmin GT56 Transducer jackplate mounting bracket, and was looking for feed from anyone that has it installed on their boat. I have a new GT56 Transducer Thai I'm...
Great - thx!
Just recently purchased two of the 126SV units and read that Garmin recommends installing three ferrite beads on the network cables XDUCER, and the LVS XDUCER cable ...
Are these necessary to...
I need help in determining the deadrise angle on my 2002 Skeeter ZX200. I will need to know the angle so that I can appropriately mount an in hull transducer, GT15M-IH. Any help would be greatly...
What is your preference for navigating and why, North Up or Course Up?
I am curious what what most anglers preference is for navigating? North up or Course up?
Who does bass boat carpet replacement in Bainbridge, GA?
So what are your thoughts regarding the P79?