Search:

Yes throttle no hotfoot. I ran it like this for a short season. I hope i didn't do any damage.

My 2008 Opti (1B529252) has no throttle in reverse. The motor just idles when I reach the end of the throttle travel. Forward works fine. Also, I noticed a slight clicking when i spin the prop in...

Did you lose any top end after installing the Ultrex? Also what lb thrust was it 80 or 112? Thanks

Pulled the prop of my Ultrex and noticed a lot of rust around the shaft seal. The TM is a 2017 model with low hours. Not sure what to do.
524600

Sounds like a good idea thanks

I have a 2008 Pantera Classic that had a motoguide mounted on the bow on 4 small rubber Motorguide isolator pads that were cut off and used as washers. I would like to use these again for my MK...

Need advice on how to repair the first 3 threads on my Opti spark plug hole in the head. Accidentally started to tighten the plug and wasn't paying attention.

Thank you for taking the time to reply Don,

I was able to get into my merc service centre and the tech swept voltage on TPS. It had a reading of .7 volts at the idle stop. I asked him to replace...

I was told if it was the TPS causing the high idle it would trigger an alarm. I am not sure if that is true..i read the neutral overspeed alarm can trigger at 1200rpm so if it is 1000rpm, then it...

I checked it repeatedly and the idle stop screw is seating firmly and the throttle cam and roller return to the proper postion. linkages also look good with no excessive play. I think it could be a...

Thanks EuropeanAM...No hotfoot. Without a hotfoot would it be ok to check the idle stop and return by putting the throttle in gear engine off or do i need to do this in the water with engine...

Hi There,

Looking for help with high idle problem. The motor starts fine and idles fine, then I when take it for a run and come off plane and back down to idle in gear it is still fine until I put...

First time post here. This is a great resource.

I am rebuilding my DB35 disc brake calipers on my 08 Pantera and noticed the brake pads do not have the piston clip or thin metal plate that the...