ARe you talking about on an HDS screen? or Pop Up Ghost Menu? Speed control, turning are both on the pop up menu under course lock,
Type: Posts; User: Basshopper
ARe you talking about on an HDS screen? or Pop Up Ghost Menu? Speed control, turning are both on the pop up menu under course lock,
The red tab is stop don't touch it there touch is on the menu stop sonar or add a configurable button for stop sonar
have you calibrated the point 1 if yes than do it again if not do it the first time.
Check the data sources for correct source checked, Turn off all stop sonar on sonar, AT and structure scan, To test the ethernet connection save a waypoint on one unit and does it save on the other...
if I am interpreting what you are saying for the time no source goes off it can take up to 2 or 3 minutes for the AT Module to boot up. That is normal
Got any pics everything you have explained is subjective. So provide a pic maybe that will help discover your issue there are so many directions this can take and again you willl be going in circles...
Do you have command link or NO?
whats the issue with out that no one is sure on your question
I bet you never ran your unit in Deep fishing mode with your other transducer either.
Untill we know what transducer you are connecting to everyone will be just guessing
To the OP the Pro comes with Discovery On Board. I will have some differences than the Reveal as the Reveal has Shaded Relief both do depth shading.
Any Lowrance dealer can get them or may have stock, BP Cabelas, Russel Marine, West Marine all these have online stores. Use velcro straps around the cover 2 of them never losse one again.
You cannot use AT with IT2 there is No ethernet on the TI2 Ethernet is required. HDS or Elite FS only
There is a very wide range of Chirp transducers that work. Without knowing how you fish what you fish and how deep you fish every one would just be guessing.
are you switching the map source to Navionics from Cmap?????
What kind of problems???????
Yes it works best on the marked lines on the transducer the 2nd one on the transducer is for forward. Its all geometry at that point if you are only getting 30 to 40 feet on the bottom then you have...
If you want this to work correctly without hassle then you need to install both Ethernet and NMea. I would suggest for the Ethernet insall a NEP box which has 5 ports then all your cables fro ea...
The most postive way to make sure your AT does not have power to it when not using it is the Yellow wire to Switch. If you have Stop Sonar on when you pull your trolling motor and then put the boat...
Is it updated to 23.3? Is Stableview turned on? Did you change anything in the mounting of the transducers or change out a Trolling motor? what else has changed? You did not mention if you don't have...
you can do it know or when the next update comes out that you want or need its like Prego its in there.
First put the transducer line on the 2nd line, Go out to 20 ft of water and give us a screen shot, also does anything change on the screen if you set to forward and then to auto on the view? I will...
The AT2 ping sync has always worked with 2 blue wires connected No need for any yellow to that with the Lives. The pro added the dual purpose switch to the Yellow wire but Ping Sync has always worked...
there is an ethernet from the AT module to wherever everyone has it different
The AI3-1 HD has great detail No real range. The 3D has great detail and big range 600ft ea side of the boat. I would never give up my 3D for those big flats to see the detail way out in range. Both...