Search:

If I remove the carpet for replacement on my 1993 17'6" Champion mod. Contender what would I find? Is it rough fiberglass or gel coat. Compartment lids are fully carpeted. What did you do with the...

Thanks for the recommendation. I spoke with Josh and purchased a prop. I settled for more of a direct replacement of my Turbo. Gave up the need for speed and stuck to safety. I will follow up once I...

How do I contact Josh at Lake Fork

I have tried several times to contact PPI to see if I had any options with no results. Thank you I will keep looking.

I posted under champion boats for suggestions but didn't ask. I have a 13 3/4 23 Pitch 4 blade Turbo M stainless prop that came on my 1993 150 mercury. Is the turbo prop still available for Mercury...

I made this post once before but lost the information I was given. I have a 1993 17"6" Champion with a 1993 150 mercury XRI EFI. My original prop I believe is a Perssion Propeller. Prop markings...

I'm entered ,never been there before. Anyone have suggestions on dock rentals for the area around Counce Tenn.

My 1993 Mercury XRI EFI 150 original motor has low compression (90s). I am the original owner. I am on the fence of rebuilding or repowering. Anyone gone through this and which way did you go?

I am looking for a prop for my 1994 17'6" Champion. It has a 150 XRI EFI Mercury, current prop is a Turbo 4 blade 13 3/4" 23 pitch. Unloaded 61 mph @5600 rpm, loaded 55 @5400 rpm. Looking for a...

I have a 200pro SX Optimax Mod.1200P73BD Ser#2B526883

Sorry about lack of motor ID. XRI EFI 150 Ser# OD286006. Don thanks for the heads up on possible damage. I contacted that site you gave in Calif. $650 2 -3 day turn around. If map sensor is need...

Thanks for the input. I dropped off at ASC today.

This was my fix on my 93 XRI EFI 50. I located 12 volts at power block at motor with key on. Wired to + post of fuel pump. Ground - to a mounting screw. Taped off factory leads. Downfall fuel pump...

I purchased new a few years ago 8' 2 stage I believe. Model 181080 Ser.# M150MK01092 Drive motor continues to drive until I push up button on remote once to stop it.

Has anyone had the drive motor continue to run after pin has locked down causing clutch to slip and get hot? What repair is needed?

Has anyone had an issue with a Talon where he fist time deployed is normal. Second time deployed the drive continues to run after pin has set. I have to stop it with remote. I smoked the slip clutch...

I purchased a PT20 left over 18 in June of 19 great price, love the deck and storage. You are right water drains into side compartments as well as two compartments behind seats. I removed rubber...