Search:

Type: Posts; User: ChampioNman

Page 1 of 20 1 2 3 4

Search: Search took 0.37 seconds.

  1. Replies
    1
    Views
    21

    Not quite sure what you are calling a poppit...

    Not quite sure what you are calling a poppit valve.
  2. Replies
    8
    Views
    325

    I went with R&L carriers CH Robinson is a broker...

    I went with R&L carriers CH Robinson is a broker and they posted several carriers. R&L was the cheapest. Terminal to terminal.
  3. You would need the diagnostic software and...

    You would need the diagnostic software and perform an EMM recovery to transfer the data. There is a repair shop somewhere in Europe.
  4. OK good luck all 4 of them have had the fault.

    OK good luck all 4 of them have had the fault.
  5. Replies
    2
    Views
    49

    Idle is an adjustable jet Here's the mid ...

    Idle is an adjustable jet

    Here's the mid
    0323149 - Orifice Plug, Number 38 used in: 2003 Johnson 150 HP (Model J150GLSTA) CARBURETOR & INTAKE MANIFOLD Parts
  6. Time to fix the ECU/EMM here in the US it is call...

    Time to fix the ECU/EMM here in the US it is call a hand full of 8's or a dead man's hand.
  7. Replies
    2
    Views
    40

    That's a test port and needs to have a cap on it....

    That's a test port and needs to have a cap on it.

    #0322892

    https://cdn.crowleymarine.com/media/images/crowleymarine/product/BRP/0322892.jpg
  8. Replies
    16
    Views
    231

    It's just to clean the threads on the flywheel...

    It's just to clean the threads on the flywheel before you install the new lift bolts. I do it every time I use the lift tool/ring and I've been doing it for a couple of summers.
  9. Replies
    13
    Views
    591

    ^^^^^ This.

    ^^^^^ This.
  10. Replies
    8
    Views
    325

    If you have it palletized, use this outfit for a...

    If you have it palletized, use this outfit for a freight quote. https://www.freightquote.com/book/#/free-quote/mode

    I shipped an engine from FL to Pittsburg for about $125 brought it to the...
  11. Replies
    13
    Views
    591

    The Dealer installed one or the stick on light...

    The Dealer installed one or the stick on light duty?
  12. Replies
    114
    Views
    3,316

    It's just about an hour from Hartwell to the Bon...

    It's just about an hour from Hartwell to the Bon Secours Center in downtown Greenville SC with assistance. Maybe a bit longer from Guntersville to Birmingham. They get thru the weigh in's just fine.
  13. Replies
    48
    Views
    1,307

    Krusteaz their Belgian waffle mix is good to. To...

    Krusteaz their Belgian waffle mix is good to. To bad no more Ant Jemammy.
  14. Bone suckin sauce.

    Bone suckin sauce.
  15. Replies
    24
    Views
    1,848

    Janie got a gun.

    Janie got a gun.
  16. Maybe call a realtor in Seneca and ask for...

    Maybe call a realtor in Seneca and ask for recommendations?
  17. Replies
    4
    Views
    122

    Yep gonna need the key.

    Yep gonna need the key.
  18. Replies
    2
    Views
    78

    Did you purchase OEM fuel hose or aftermarket...

    Did you purchase OEM fuel hose or aftermarket like Attwood? Primer bulb should have the yellow ends on it.
  19. Replies
    1
    Views
    51

    Didn't want to spring for the manual huh? 23-25...

    Didn't want to spring for the manual huh? 23-25 foot pounds, don't forget the roll pin on the crank.
  20. Replies
    2
    Views
    95

    Sure why not as long as you can get parts. And...

    Sure why not as long as you can get parts. And find the root cause of the failure.
  21. Replies
    16
    Views
    231

    Model number would help.

    Model number would help.
  22. Replies
    2
    Views
    62

    Yes. Support motor on trailer bracket, remove...

    Yes. Support motor on trailer bracket, remove upper tilt pin and run trim down TnT assembly can drop back towards you. Motor can be removed at that point. Need to push the female spade connectors...
  23. Replies
    10
    Views
    194

    Sudden impact with submerged object. Prop stops...

    Sudden impact with submerged object. Prop stops spinning flywheel continues. Make sure the roll pin is still in place on the crank along with the 5 flywheel bolts.
  24. This is the VRO/OMS pump, if still installed it...

    This is the VRO/OMS pump, if still installed it will be on the port side just ahead of the starter.

    https://www.marineengine.com/parts/images/hg/omc/5007420.jpg
  25. Go to the Evinrude site and use the find a dealer...

    Go to the Evinrude site and use the find a dealer option.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4