2002 procraft f&s
i dont see a lot of options for mounting the transducer on this boat with the stepped hull. Any recommendations?
Type: Posts; User: Hogwash
2002 procraft f&s
i dont see a lot of options for mounting the transducer on this boat with the stepped hull. Any recommendations?
J90tslecm is engine model. I get 4900-5000 rpm
That’s with just me
This Cherokee 207 is a V hull with 90 Johnson. Boat runs great but all I can get out of it is 36 mph. The prop is a 14 x 19. I really think this boat should do 42 ish from other boats I’ve owned.
...
Does anyone have a wiring diagram for the if ignition and temp gauges?
1999 ranger Cherokee
the steering wheel has play before it engages the cable in the helm box. Can the box be replaced without the cable also or is it all one piece?
I don’t think there is but is...
I tested it today with a flooded cell battery. I still have low voltage. With nothing on electronic wise I had 12.7 at idle and with i idled it up would go to 13.2. If I turned on electronics or...
It’s an Optima blue top. Resting voltage according to them 12.7-13.2
Follow up on this charge issue.
I replaced the stator and rectifier with CDI parts. I it on hose in driveway afterwards and it charged great 14.5 ish volts. Weather has been bad so today was...
Haven’t had boat long but I have a on plane lean to the left. Sits flat at rest and not loaded uneven. It seems to level out slightly at full throttle. I did read something about prop torque causing...
J90tslecm
I just like know I have charging voltage. I put one on motorcycle also.
it’s carbureted
I just saw something on web that you can’t run AGM battery on older outboards. Has anyone heard this?
id correct then I fried something
New Optima battery fully charged. Oh the tach also quit. It worked last time out
I just put a voltage gauge on boat and took it out today. I would get 12.4 to 13 volts at high rpm. Can someone point me in right direction to test issue?
1998 ranger Cherokee 207 v hull with 90 Johnson 14-19 pro on it
i get about 37-38 top end speed. Is this about what I should expect or can I get a little better top end with a different prop?
How in the world are you supposed to access the bildge pump? It’s running and pumping waterbecause you see it swirling around. Seems the hose is off or something but you can’t see in there
I was just wondering if fishing shallow was going to be a issue
One more thing you guys may know. Mine is a V hull. Do you know what the draft is?
it has a 12v motor. I figured that’s what it was. Thanks for the reply guys.
Just picked up this boat and noticed there is a 3rd set of battery cables and circuit breaker that is not connected to anything. I assume it would be for a 24v trolling motor??? Anyone know for sure?...