Search:

I use Senkos, Zoom G tail, ring worms, Mag 2s and old monsters in black. No issues finding them.

What prop?

Power poles, best customer service by far, mine are long out of warranty and they still sent me some replacement parts for free.

61 is pretty good for an underpowered boat.

Junk, never worked right from the beginning. The regular Tour is a great trolling motor though.

You can, but you shouldn't.

Another thing is I was letting if idle for a few minutes and got a warning beep with a message saying thermostat needs serviced. However it idles between 125-129 degrees which seems normal to me.

Good call, the bushing is gone but the pin is still there.

The PTR3 was a great prop on my Tracker, fastest one I used, handled great, and had an excellent hole shot. How high do you have the prop? That may be your issue if it is too high.

It did it once again, but ran fine after. I calibrated the trim sensor and it worked correctly, but next time on the water it quit working, it reads 0 all the time now.

Are you running premium fuel?

Mine came factory with a 10" plate, no issues at all.

Had one, transfer case and rear axle both went bad, then the engine blew. Only vehicle I have ever had that blew an engine.

Buy a used one with a little bit of damage for $200-250, send it in to Marks prop shop and spend a few hundred to get it fixed, balanced and blueprinted and you will have a prop that works better...

Relived would be a more accurate description.

Can't void the warranty unless they prove an aftermarket part caused the damage, that is the law. If you are that worried about it, if the transom ever cracks just take the jack plate and poles off...

Mine is mounted here.
548830

I converted my hubs to regular grease. Lost a whole wheel, tire, hub and spindle because of the Vault hubs.

Slower for a Triton, meaning it wouldn't run close to 80 like a TR or HP hull with a 250 will, but it's still a 72-74 MPH boat when set up right. The fuel tank is under the seats, and floor.

Love mine, labs are the best.
548790

Any of them are fine, the best ones are the ones that have been worked and blueprinted by a good prop shop. Its best to find one slightly damaged for cheap and send it to a good prop shop like Mark's...

8 gauge is fine, I ran that same trolling motor on my Tracker for years with 8 gauge wire, never had a problem.

Just get a sleeve that zips up around everything.

I have been using them for about 15 years and have never had that happen.

Max PSI is not the required PSI, just because the Max PSI on the tire is 15 lbs more doesn't mean that is what it requires. The load charts listed are what the tire manufacturer calls for. You will...