So as the OP, I run a dedicated electronics battery. After wiring my drain to the negative block of the house battery the corrosion of the screws has appeared to stop. I did not run the wire direct...
Type: Posts; User: Beallright
So as the OP, I run a dedicated electronics battery. After wiring my drain to the negative block of the house battery the corrosion of the screws has appeared to stop. I did not run the wire direct...
Thanks, not one site or through the "chat online" has stated that.
I put the Boat EFX on my 2023 920 elite
Found a listing for a fury Demo prop. I found it on multiple websites so I am curios if anybody has ran across this tried one and results or what it even is.
Mercury Marine / Mercruiser New OEM...
:newyear: the camera left them pretty quick
is there any talk of of a DI only Quest? I get my side from my 360.
I use 360 and active target, 10ft or greater active target 10ft and less 360. IMO 360 is far superior to my active targets shallow. Out deeper the active target out shines the 360. Interferance is...
Boater for BFL is 220 for one day, 330 for 2 day and regional.
Co's are 110 for one day and 165 for 2 day and regional
95 Tournament membership
I am considering purchasing a c-map card for my Lowrance Pro. My console and bow are linked and use and share the Navioncs map card between the two. I have an empty SD slot on the bow but not on the...
Are you looking for the image as a home page background or a Mercury logo page such as what is present with vessel view?
2023 Pro XS SN:3B394985
So I drop by my prop shop to purchase the SSR hub for my spare prop. The Prop guy stated that the SSR has a bulletin out and Mercury now recommend the solid hubs. I asked...
I have a dual pro 3 bank from a 2005 ranger. Hasn’t been used or tested in several years. It was a spare.
It is not needed at all times, garage clearance, 2 that I know of have been stolen. just a few of the reason for me. Backing is not an issue for me, Co angle now that another story at times
Trick step said they don't make one removable just an anti theft add on
I am looking to add a bow step to my 920 elite. Has anyone found one that is removable? I saw on at the ramp parking lot no name on the step, basically a hitch receiver with a locking pin.
Everything is connected and verified. If I go to drain/ground and the screws I get 11 ohms on a fluke doom
The Mega 360 power along with all my electronics are on a dedicated separate 125 Lithium battery. Then drain and ground are attached. Verified with an ohm meter the integrity of all wires back to...
Helix 12 Mega DI G4n connected to A MEGA 360 via a Y cable from a Integrated DI on trolling motor. On my 360 full screen I can select front view for my 360 (my preferred view) but on all other...
So my confusion continues,
5. Mercmonitor CANNOT function as a Vessel View. You will not have a Vesselview Page on your graph UNLESS you install VesselView Link (or for some graphs, Smartcraft...
So what the point of the NEMA then on the level 3 gauge. On my last boat a 2014 Ranger it was suggested tha I upgrade from a level 0 to a level 1 or higher to get the data displayed. For what it’s...
Phoenix boats did the gauge install, but did not connect it to NEMA. I connected NEMA and disconnected the ext power after NEMA hook up.
Serial 3B394385
Merc monitor Level 3 version 9.0
The level 3 option is what I choose for my boat, As a result of this option I have no fuel gauge. Attempted the default calibration mode, and now...
Getting a new and first Phoenix a 920 Elite, I would be interested in one as well. Blue
Thanks all I found it with the model number Don provided. I have been scouring the FAQ, hope this 4S is as trouble free as my 2S is.
If you need Mercury service I have had good luck with Tomahund Marine, And Now Propeller Dynamics has a certified Mercury guy as well.