ok guys Update: I got it fixed last night. I used some of the advice from the link shared below and also talked with a mercury service guy who told me its a pain but does happen. I used some...
Type: Posts; User: Openfacereel
ok guys Update: I got it fixed last night. I used some of the advice from the link shared below and also talked with a mercury service guy who told me its a pain but does happen. I used some...
Thank you for posting this, really helped me.
Thanks for the reply and information- I called a shop this morning and he basically said the same thing as you. He said it will be find but have to get it just right in order for it to go. its...
Hello all, My motor is Ser # OG569909 1997 200 EFI
I have an issue I have never seen before ( Pic included) I pulled my lower unit off to change water pump which I have done several...
You should go look up Ken Smith Fishing on youtube, search his channel for something called " the Great bass boat search of 2021" absolutely the best boat brand review. he does complete walk...
Hello all, Serial # OG569909 1997 200HP EFI
Having a sporadic issue when trying to get on plane, sometimes it acts like its starving for fuel and will bog down but then finally catch and...
sounds like since it runs fine after the hole shot that you just need to put a plug in one of the vent holes or a partial plug. you can get the plugs at any dealer or order online, there are a lot...
I sent you a PM with some details of a great place to go.
leonreno, thank you ! good info and very helpful. I will check tonight
Hello guys,
I have a 1997 EFI 200hp. Ser# OG569909
Yesterday while running the boat I noticed coming out of the hole the guage shot to the max mark then dropped back down. While running down...
I would agree with the other guys regarding doing it at the boat ramp. what I have done is measure and cut the boards I need, go ahead and carpet them so they are ready.
Once unloaded just takes...
Thank you
Hello all, I have a 1997 EFI 200hp. Ser# OG569909What oil is recommended for this engine ? is Synthetic ok or just regular 2 cycle Mercury/Quicksilver ?
I appreciate any clarification or...
Thanks guys for the information I will check out the Jackplate forum, I missed that.
BalsaBee, Thank you
Hey guys , I have a 1997 Champion 191 currently with a Rite hite jackplate. I was going to make an adjustment however the set screw
underneath that tightens up against the big screw has...
Go all the way north. Lake Kabotagama in mid June. its about 30 minutes from international falls. You can fish several lakes including the American side of Rainy.
Great scenery, Voyager...
Ok Thanks guys, That's pretty much what I was thinking, just needed some clarification. and yes its a Merc 2 stroke 200HP Based on the setups page the 25P temptest is what I should be...
Hey guys, My out of the hole performance is not good in my opinion. Can someone clarify my thinking on this? To have better out of the hole performance I would want to use plugs ?? or maybe...
Hello all,
I am back in the Champion family again, thank goodness! but need a little help. I have searched the forum but cannot find specifics to my questions.
I really appreciate any help ...
Thank you!!!!! I will check it out. Thr wiring may be an issue also. The current trim motor has 3 wires but the replacement appears to have 4
1997 200 EFi serial # OG569909
My trim motor stopped working, trim pump Motor appears to be burn up and not working. Need guidance on replacement. What Is the best way to raise the motor...
Hello all , 1997 EFI 200hp. Ser# OG569909
I have an issue with my motor, it appears to be either the
High pressure fuel pump or brain. I was told the brain is most likely losing ground but that...
All very good feedback , I truly appreciate it!! Thanks guys
Really appreciate the feedback