Search:

Why you replacing your ghost? To quiet?

That will never happen because as the Judge Says "Garmin will shall all FFS tech with Lowrance" For stealng Lowrances design.

Down and SIde are 2 different Icons Change the frequency to 455 till you get it going. 800 is very hard to see over 10ft deep

Where did you read about the AT3?

What version of software are you using? Take the card out and use the CMap built in and see if the problem goes away.

The range and image is greatly improved on the AT2. So if you want that then good time to upgrade.

How about a pic of what you are seeing. Image can tell us a lot of about what is going on.

The reason your autopilot message comes on is you don't have all 3 autopilot switchs that the ghost uses it is an autopilot. Make sure all 3 are turned on then the message will go away. Another...

Take it back to the dealer Depending on what you have you could have u 1 or 2 year warranty

Good to know you have a ghost. Can you post a pic of the noise There are lots of different reasons for noise that may help narrow down where it is coming from. The Brushes are the most common so you...

Are you looking on the Data Sources? Or Device List Its not on the Device List.

If you have a TM with brushes that is as old as horse and buggy, If you have a GHost with brushless motor no noise. Its based on your TM and no unit is immune from it with out some kind of chokes and...

I must have missed you already had a LSS2 I would have said stay with that. Good to go

I just tested the thumb drive, 10gb

Can copy from any My FIles to MSD
Can Log Sonar to MSD Mass Storage Device
Tried Recording AT No Go at least at this point
Tried Recording Sonar Live...

I am assuming you want SI and Downscan. If you want big water large area to search than I would get the 3D SS it will look out with very good detail 600Ft ea side of the boat You can mount on Jack...

May 5th sale starts

Do you have a pic of the interference you are getting? Have never seen triangles

The 3-1HD has mega Hz when hooked to a Pro of with the 3100 module. YOu can actually see fix on side image with that high frequency, Does not have the range as that is a conquence of higher...

TI2 have wi-fi sharing set that up its in the manual You can share transducers, waypoints possible maps

come on do a restart and at least let us know it would work that way. What you got to lose LOLOLOLOLOLOL

Have you also tried to log sonar to that port ?

IT is very difficult to get a 3-1 to work at high speed,Your best option is to install a PD-WBL puck in your hull for high speed running and mount your 3-1 on a aftermarket bracket on the side of the...

As I mentioned above you go to the Sonar page Menu go to the bottom and find source select what you named for running and switch back to 3-1 when hunting

Change your fishing mode from General which means you fish in 1000ft and in Tn you should be set to Shallow 60ft or less

With no Point 1 on the device list you have a NMEA backbone problem. You have a bad connection or a defective Tee or cables somewhere. The first place to start is make sure you have power to the NMEA...

You will not gain any performance out of the in Hull. If it assuming its hooked to your console unit I would leave there so if somethings happens you can at least have that to run on. If I remember...