Yes, it is the regulator, brain fart. So am I ok to leave it off? I spoke to CDI tech support and they said it was a sign of a bad regulator and an old cranking battery could have burned my new...
Type: Posts; User: Bill in Pa
Yes, it is the regulator, brain fart. So am I ok to leave it off? I spoke to CDI tech support and they said it was a sign of a bad regulator and an old cranking battery could have burned my new...
I put new CDI power pack on this summer. My dealer put one on last spring and when I had it there a couple months ago they said it was the problem again. When I took the 1 year old power pack off...
I should add that the power pack was replaced at the dealership last spring
Thanks, when I had it at the shop they said there was power to the tach but I’ll double check everything
Little update, ended up buying a double kit on Amazon and evenly spacing the pads on all 4 bunks. I did buy stainless #10 x 2 or 2-1/2 bolts and lock nuts. Through bolted all of them. Wish I did...
I haven’t had a working tachometer for a while. Replaced the regulator yesterday hoping that was it. The tachometer jumped when I turned the key on but that was it and now the motor has a skip above...
I didn’t, thanks. I’ll put it in that section, was in a hurry this morning and didn’t see the evinrude board
I haven’t had a working tachometer for a while. Replaced the regulator yesterday hoping that was it. The tachometer jumped when I turned the key on but that was it and now the motor has a skip...
Did you put them on all 4 bunks or just the two center/longer bunks?
Thanks, I think I’m going to order some tonight. My neck and lower back have seen better days and i broke both bones in my wrist and 7 ribs in the fall along with hip and shoulder injuries so I’m...
I fish a lot of electric motor only lakes. Mainly fish with father who is 93 so I don’t want him cranking on it either. I do have a TRAC 10000 electric boat winch that I’m going to try again if I...
I have a 1998 Stratos 295. How would the Teflon pads work and what brands has anyone tried? I had a fall on a job site last year and haven’t had my boat out since as a result. I know retrieving...
Thanks, all cylinders are within 5 pounds, did a quick spark check but my harbor freight spark tester doesn’t work. Weather has turned here so I’m into research mode. I have also read where a...
I’m missing on one cylinder, bottom right as you look at the back of the motor. Plug is black, changed coil with no luck. Any suggestions?
Looking for an original Raker 14-1/2x24. On 1998 Stratos 295pedc with a 200 Evinrude Vindicator. Anything comparable. Looking for lift and a little in hole shot. Ran a renegade for a while...