There's a 36V lithium battery out there that has 12v taps.
Type: Posts; User: blkfalc4
There's a 36V lithium battery out there that has 12v taps.
51 on Squam, Monday the 29th
https://www.easternmarine.com/tie-down-engineering-master-cylinder-kit-47267k
More specific please on both?
You connected both ducers to 1 apex?
I connected 360 to one and tm si to other unit. Is that the best way? Figured it was really the only way, but always open to...
Just replaced my ultrex 112/45" for a 45" quest.
Works great.
Thanks Wayne...the feedback is very much appreciated.
So if I replace the helix 15 with a apex 16, I'll be able to I take it?
2 Apex 13 at bow, 1 has m360 connected and other has built in Quest SI ducer connected. TL and ML connected enet.
1 Helix 15 4n at console connected to transom SI and 2d puck in hull.
Can the...
Sand down old epoxy and reinstall new.
2x4 and hammer.....
And technically it's a shoot-thru, a thru-hull has a hole drilled for the stem and cable.
I got them from Hydrilla Gear.
I bought different lengths for the purpose.
Check the fuse under the TM cover. Is the main switch wired for a TM batt jumper?
Easy enough to experiment with.
Yes, I have. Remove the TM from mount. thru the mount nose, pry barrel from the plastic tabs with a screwdriver. Now you can feed cable to get to barrel locking screws. Take note of cable routing.
It's just 2 pieces of extruded aluminum angle. They don't move at all.
No tray here, not really necessary with LiPo.
https://www.bbcboards.net/attachment.php?attachmentid=531060&d=1693146539
Relay assembly
Nothing on Great Lakes Skipper site?
Damn, must of been bad from their vendor as the magnets are now part of the rotor on Quest.
548447
Some more ETEC techs > https://www.etecownersgroup.com/categories
https://www.bbcboards.net/showthread.php?t=1232663
I utilize the point1, that is used for my engine, on my console mounted Helix 15 g4 thru nmea.
What is the recommended psi? Should be on the trailer reg plate or sticker up front, near the 'V'.
I bought mine thru my dealer. They didn't require it to be installed by them. I made it removable on my rig.
It was complete, matched to driver's console and it was like $1100 otd.
