We currently are running a 300xs with DBR kit .Years ago I hurt the motor from not letting it warm up long enough when cold.Life went on and we did more wakeboarding so the boat has sat hurt for...
Type: Posts; User: aaronmt
We currently are running a 300xs with DBR kit .Years ago I hurt the motor from not letting it warm up long enough when cold.Life went on and we did more wakeboarding so the boat has sat hurt for...
I've heard some guys have been fooled by this before.Hot running 200?
.
Ive always run a blend,just never been sold on full synthetic. Im not sure that would changed theoutcome but uts wprked for me.
Id debur and gasket match everything while you have it apart.I never had my 225x aprt but i was amzed on 225 opty how bad the tuner and adaptor plate were.I do miss that 225x,had her between 7k-7.5k...
SPOT ON!!!!
SPOT ON!!!!
You aren't the only one.
Never heard any I'll will towards Brucato.I had great service as well.
I had a 04 250xs and had Simon flash it to the 05 program.Its the same just far easier to prop with higher limiter.You wont see any increase really past 6200 or so.I had a tuner as well as match...
I have the dbr kit as well as balancer removed.I original was running 1.62 gears then switched to 1.75s the difference in acceleration is incredible.I was running 23~25p props now run 27~29p props.
Serial number?
Id hold off for a hydrp.I ran maual for many years and recently went hydro.Ever prop runs different at different heights as well as differenr weights.I litterally adjust mine will watching the gps...
If the boat is 20ft and over the hp rating is manufacture rating not USCG.
So whats the consensous on lightest, fastest hull the champion 21xs or Coral or something else.Do these have pads or are they true V.
This is not about what a ALLISON can do on top end with miles upon miles of running.There is no way in he.ll that a ALLISON is a the same type of boat as these fish and ski hulls.
Anyone running a 300xs on a fns?20ft and over are not governed on hp,more so just mfr recommended hp.That being said what ya have and what speed you seeing?
I use Pennzoil xlf and have used it for years, its treated me great.Get oppinions of guys without vested intrest in selling a paticular product and your more opt to get a un biased opinion. Heck id...
I ran mine in the low 80s and about 1/4" below the bad at 12"s back.I honestly like it them a bit more since they have the small shaft,seem to have far less seal issues.I may get one and send it to...
So what all needs to be done to the 29.I ha x27 that was b&b by mark but justnt wasn't enough pitch.I now have a perfect 29 but hear they need attention when stock.What all do they require to make...
I dont think theres anyway id run that motor without pulling the head to make sure.
Non ethanol would be the best run but you can run ethonal as well.As long as you run fresh premium your good to go.
Im skeptical as well.However its the same guy that owns 2 2013 300xs and 1 07.He says the 07 is a unpainted block so I assume is a early one its 110 on all 6.He looked at the head castings and there...
Were there any differences in years.I know 2007 300xs are around 110psi.Some are seeing the compression on the 2013's around 140psi.Looks to me the heads are the same.
Ended up find a 27 trophy plus thats basicaly new.Depending how it runs ill decide if Im goind tk sell my beloved 26 a45 trophy.