I have had three done. I totally agree with first post
Type: Posts; User: FLYING BUTCHER
I have had three done. I totally agree with first post
Ihave only used a couple items but they worked fine. Good luck
Not much at all in Denver. Horsetooth in Ft Collins. Pueblo by far best fishing within a couple hundred miles around Denver.
Second everything said above
I did a search but did not find a current post. I am taking five adult family members out for a day off fishing in early October. I am looking for charter service. Can any of you give me some ideas?...
I looked in search but didn't find a current post.I am taking the guys out for a day of fish this October. Can someone post a good charter service for 5 people? Also what percentage tip is...
There is a shaft located outside infront of the lower unit its self. That has to slide over the the splines in the lowerunit. It is about 1/4" around. Let the lower unit down and use your fingers to...
I can tell by your posts you are trying to "milk" everything out of your Allison. I didn't listen and doubt you will but let me just throw this out there. Your boat isn't anything different than the...
Weight and design of boat. Lip doesn't matter. I've run with and without. On my boats it needed the lip.
Be careful, if you get to high it will blow out, dona bat turn, and you will get wet!
My 2 cents. Ran them for years. 14" set back and try dropping the engine a 1/4" at a time. I think you will find higher top end by not running the engine so high. Higher isn't always faster. Have fun...
I'll give them a call. Thanks
Looking for a stock o ring 280 cylinder head. Anyone have one?
Well crap Wayne, it says file to large have to load manually. I can text or email them to ya. Sorry for so much trouble??
Here are a couple showing no reading on any screen and the boxes with vessel voltage checked??? Hum, don’t see paper clip to add pictures. Can anyone help ole guy out on how to post pictures?
I went to each box and checked voltage. Still doesn't show on screen. Everything else shows???
I did the current software update two weeks ago and have reset to factory setting. Still no voltage reading. Should I try to install same update again?
I used 10 gauge wire to run to battery. My problem isn't so much voltage as the voltage reading doesn't show up at all!! Everything else, temp, time, speed, depth etc all show up just no voltage...
On my new Helix mega si di plus 8 gen 4 the voltage doesn’t appear any longer. Anyone know how I can get it back?
For some reason the voltage isn't showing on my new Helix mega 8 di si plus. Anyone know how to get it back? Thanks in advance for any help guys.
I am looking for a used water ski pylon to put on my tritoon. Anyone?
The 280 doesn’t work well idling around that’s for sure. I don’t do much of that. I don’t like the cle lower unit at all to say the least. They have way to much rear end lift. Even coned they would...
Do not try to put heavy engine on her. 2.5 Merc for sure. Three blade props, 28 pitch ok, for me I would like a 26 a little better just for acceleration, but to each his own. 10-12” set back....
Anyone have a 20” sportsmaster 2.5 drive shaft they would like to sell?
Anyone have one the want to sell?